ekco EV55SE Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para Amplificador ekco EV55SE. ekco EV55SE 13 páginas. Valve integrated amplifier
Também para ekco EV55SE: Manual do utilizador (12 páginas)

Imprimir página
IMPORTANT SAFETY INFORMATION
CAUTION!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK)
NO USER-REMOVEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED PERSONNEL
AVERTISSEMENT: RISQUE DE CHOC ELECTRIQUE-
NE PAS OUVRIR
This symbol indicates that there are important operating
and maintenance instructions in the literature
accompanying this unit.
This symbol indicates that dangerous voltage constituting
a risk of electric shock is present within this unit.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only as recommended in these instructions.
Do not block any ventilation openings.
Install in accordance with the manufacturer's instructions.
Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wider blade or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
Use only attachments/accessories specified by the
manufacturer.
Use only with a cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
Unplug this apparatus during lightning storms or when unused for
long periods of time.
Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
Warning: To reduce the risk of fire or electrical shock, do not expose
this product to rain or moisture. The product must not be exposed to
dripping and splashing and no object filled with liquids such as a
vase of flowers should be placed on the product.
No naked flame sources such as candles should be placed on the
product.
Caution: Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this device.
This equipment has been tested and found to comply with the limits
for a Class B digitial device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be
determined by tuning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Re-orientate or re-locate the receiving antenna. Increase the
separation between the equipment and the receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
Mains Supply: The mains operating voltage is shown on the rear
panel. If this voltage does not match the mains voltage in your area,
consult your dealer about converting the unit.
The mains supply fuse on the rear panel is accessible when the IEC
mains plug has been removed. In the rare event that it has broken,
check for any obvious cause before replacing the fuse with one of the
correct rating and type. The fuse values are:
220 - 240V (UK, Korea, etc.)
T4.0AL 20mm Slow Blow
100 - 120V (USA, Japan, etc)
T 10.0AL 20mm Slow Blow
IMPORTANT NOTICE TO UK USERS
The appliance cord is terminated with a UK approved mains plug
fitted with a 5A fuse. If
the fuse needs to be replaced, an ASTA or BSI
approved BS1362 fuse rated at 5A must be used. If you need to
change the mains plug, remove the fuse and dispose of this plug
safely immediately after cutting it from the cord.
Connecting a Mains Plug
The wires in the mains lead are
GREEN
coloured in accordance with the
YELLOW
code: Blue: NEUTRAL Brown: LIVE:
(EARTH)
Green and Yellow: Earth. As these
colours may not correspond to the
coloured markings identifying the
terminals in your plug, proceed as
follows:
The BLUE wire must be connected to the terminal marked with the
letter N or coloured BLUE or BLACK. The BROWN wire must be
connected to the terminal marked with the letter L or coloured
BROWN or RED.
The GREEN & YELLOW wire must be connected to the terminal
marked with the letter E or coloured GREEN or GREEN & YELLOW or
marked with the Earth Symbol
.
CAUTION: This appliance operates on very high
voltages. DO NOT remove covers or dismantle. This
is very dangerous and could cause severe shock.
BATTERY WARNING: The handset uses two AAA batteries. There is a
risk of fire and burns if the batteries are handled improperly. Do not
disassemble, crush, puncture, short external contacts, or dispose of
in fire or water. Do not attempt to open batteries.
When the handset operation becomes erratic: replace the
batteries with a pair of new batteries of the same type and
construction.
Discard used batteries in accordance with recycling regulations in
force in your area.
FUSE
&
BLUE
BROWN
(NEUTRAL)
(LIVE)