Ekinex EK-BW1-TP Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Automatização doméstica Ekinex EK-BW1-TP. Ekinex EK-BW1-TP 4 páginas. Knx voice control interface

Imprimir página

Note. The RESET button is not directly accessible on the front

panel of the product. To access the button, open the front panel

of the delégo server using a small slotted screwdriver and exer-

ting a slight leverage effect in one of the side slots. Locate the

RESET button on the back of the vertical board at the bottom of

the device towards the KNX terminals.

Mounting

The device has degree of protection IP20, and is there-

fore suitable for use in dry interior rooms. The housing is

made for rail mounting according to EN 60715 in boards

or cabinets for electrical distribution. The installation is in

horizontal position, the correct position is when the KNX

bus terminal is located at the bottom and the terminals for

the outputs are located at the top.

For the installation of the device on the rail proceed as

follows:

• with the aid of a tool bring the locking device in the fully

lowered position (1);

• place the upper edge of the rear inner profile on the

upper edge of the rail (2);

• rotate the device towards the rail (3);

• push the locking device upward until it stops (4).

Before removing the device, be sure the inputs have been

disconnected and the bus terminal has been extracted

from its slot. Use a screwdriver to slide down the locking

device and remove the device from the rail.

Note. It is recommended that the installation of the device

always ensure the full accessibility of the front side to allow the

led visualization.

Power 12-24 Vdc

The connection to the power supply is made via the

screw terminals (1)+ and (2)- located on the removable

2-pin connector.

Clamp characteristics

• Screw tightening of conductors

• Max. conductor cross-section 2.5 mm2

• Recommended conductor stripping approx. 6 mm

• Max. torque 0.5 Nm

Warning! The electrical connection of the device may only be

carried out by qualified personnel.

Connection to the KNX bus network

The connection to the bus network is made via the KNX

terminal included in the scope of delivery and inserted

into the housing on the front of the device at the bottom.

KNX clamp characteristics

• Spring clamping of the conductors

• 4 conductor seats for each polarity

• Suitable for KNX bus cable with single conductors

between 0.6 and 0.8 mm diameter

• Recommended conductor stripping approx. 5 mm

• Colour coding: red = bus conductor + (positive), black =

bus conductor - (negative)

Warning! Only use KNX bus power supplies (e.g. ekinex EK-

AB1-TP or EK-AG1-TP) to supply the KNX bus lines. The use

of other power supply devices can impair communication and

damage the devices connected to the bus.

Configuration and commissioning

The configuration and commissioning of the voice con-

trol interface must be carried out by accessing the web

server integrated in the product. These activities must be

carried out in accordance with the design of the building

automation system carried out by a qualified professio-

nal.

EK-BW1-TP

Voice control

EK-BW1-TP

Voice control

bus KNX