AstroLink 4 Pi Manual - Página 8

Procurar online ou descarregar pdf Manual para Accionamentos DC AstroLink 4 Pi. AstroLink 4 Pi 17 páginas.

AstroLink 4 Pi manual - astrojolo.com

Software installation

The recommended software is the Astroberry system that can be downloaded at the site

https://www.astroberry.io/. Astroberry installation procedure is described there in detail. After the

first run, you need to update WiFi settings and connect to the home wireless network and update the

system. Do not remove the default astroberry WiFi hotspot, that is used as a failover if it cannot

connect to any other configured networks.

After that step, two more actions are required. Open Raspberry Pi Configuration and in the Interfaces

tab enable 1-Wire – this is required to read data from the temperature sensor. Then in the

Performance tab enable the Fan section, and select GPIO pin to 13. Then adjust the temperature

when the internal fan starts to work. The recommended setting is 60-70C – to be on the safe side.

When the CPU reaches that temperature the cooling fan will be switched on.

All these actions above are not required when you purchase AstroLink 4 Pi device with the

preconfigured system.

AstroLink 4 Pi INDI driver is available at the

https://github.com/astrojolo/astrolink4pi

page. Required

installation steps are listed in the README file.

Driver installation is not required when you purchase AstroLink 4 Pi device with the preconfigured

system.

The configuration below will be presented for Kstars/EKOS system.

The first step is to create a new hardware profile. Click plus icon next to the profile selector and fill it

with all the equipment you have. As one of the Aux devices select AstroLink 4 Pi. Then click Save.

Figure 6- EKOS profile editor

Rev. 1.0