Air Hogs Zero Gravity Laser Manual de instruções
Procurar online ou descarregar pdf Manual de instruções para Carro de brincar motorizado Air Hogs Zero Gravity Laser. Air Hogs Zero Gravity Laser 4 páginas.
Imprimir página
®
TO GET THE MOST OUT OF YOUR
ZERO GRAVITY LASER™
WALL RACER PLEASE READ THESE
INSTRUCTIONS FIRST!
Check to make sure contents are
complete:
• 1 Zero Gravity Laser™ Wall Racer
• 1 Controller/Charger
• 1 Instruction Guide
BATTERY INSTALLATION
CONTROLLER/CHARGER
Battery
Compartment
Six 1.5-V AA
Alkaline Batteries
1. Requires 6 1.5-V AA alkaline batteries.
2. Open the battery door with a screwdriver.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install new batteries as shown in the polarity diagram (+/-) inside
the battery compartment.
5. Replace battery door securely.
6. Check your local laws and regulations for correct recycling and/or
battery disposal.
4. Slide the
switch to
the "Charge"
position on
the controller.
CHARGE
OFF
ON
• Charging should take bet ween 30 and 50 minutes depending on how much charge is left in the car.
• NOTE: Do not charge battery immediately after use. Let the car battery cool for at least 10 minutes.
Your Wall Climber has a pre-installed rechargeable battery inside the vehicle body. (Rechargeable battery is not replaceable.)
INSTRUCTION
GUIDE
Battery
Compartment
Door
5. Red light flashing:
Vehicle is charging.
Green & Red light
flashing together:
Vehicle is charged.
Green & Red light flashing
alternatively: error.
Green light
flashing/Red light off:
Replace AA Batteries.
If charging is not complete in 50 minutes, replace the charger batteries.
NOTE: USE ON SMOOTH, CLEAN
SURFACES ONLY!
FOR INDOOR USE ONLY.
ADULT SUPERVISION RECOMMENDED!
Zero Gravity Laser™
Wall Racer
CHARGING YOUR ZERO GRAVITY LASER™
1. Switch
car to "OFF".
OFF
3. Take out
charger
plug and
plug into
car.
Red
Green
LED
LED
1
Controller/Charger
2. Switch
controller/
charger to
"OFF".
CHARGE
OFF
ON
6. When
charged, turn
controller/
charger
switch to
"OFF".
CHARGE
OFF
ON