Air Hogs Zero Gravity Laser Інструкція з експлуатації
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшкова машинка на колесах Air Hogs Zero Gravity Laser. Air Hogs Zero Gravity Laser 4 сторінки.
Друкувати сторінку
®
TO GET THE MOST OUT OF YOUR
ZERO GRAVITY LASER™
WALL RACER PLEASE READ THESE
INSTRUCTIONS FIRST!
Check to make sure contents are
complete:
• 1 Zero Gravity Laser™ Wall Racer
• 1 Controller/Charger
• 1 Instruction Guide
BATTERY INSTALLATION
CONTROLLER/CHARGER
Battery
Compartment
Six 1.5-V AA
Alkaline Batteries
1. Requires 6 1.5-V AA alkaline batteries.
2. Open the battery door with a screwdriver.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install new batteries as shown in the polarity diagram (+/-) inside
the battery compartment.
5. Replace battery door securely.
6. Check your local laws and regulations for correct recycling and/or
battery disposal.
4. Slide the
switch to
the "Charge"
position on
the controller.
CHARGE
OFF
ON
• Charging should take bet ween 30 and 50 minutes depending on how much charge is left in the car.
• NOTE: Do not charge battery immediately after use. Let the car battery cool for at least 10 minutes.
Your Wall Climber has a pre-installed rechargeable battery inside the vehicle body. (Rechargeable battery is not replaceable.)
INSTRUCTION
GUIDE
Battery
Compartment
Door
5. Red light flashing:
Vehicle is charging.
Green & Red light
flashing together:
Vehicle is charged.
Green & Red light flashing
alternatively: error.
Green light
flashing/Red light off:
Replace AA Batteries.
If charging is not complete in 50 minutes, replace the charger batteries.
NOTE: USE ON SMOOTH, CLEAN
SURFACES ONLY!
FOR INDOOR USE ONLY.
ADULT SUPERVISION RECOMMENDED!
Zero Gravity Laser™
Wall Racer
CHARGING YOUR ZERO GRAVITY LASER™
1. Switch
car to "OFF".
OFF
3. Take out
charger
plug and
plug into
car.
Red
Green
LED
LED
1
Controller/Charger
2. Switch
controller/
charger to
"OFF".
CHARGE
OFF
ON
6. When
charged, turn
controller/
charger
switch to
"OFF".
CHARGE
OFF
ON