Daema DWF-1318XLE Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa Daema DWF-1318XLE. Daema DWF-1318XLE 8 páginas.
Imprimir páginaHow to Install
Installing the bottom cover
1. Slowly lean the unit facing up/down on soft object.
2. Push the bottom cover into the base slot.
3. Use the screw to fix the bottom cover onto the base
of body (a small hole in the middle of the
bottom cover), then slowly lift up the unit.
Placing the washer
1. Install the washer, adjust the Adjustable Feet if
surface is not level. The distance between the
tub and cabinet should be the same (left & right,
front & back).
2. Distance between washer and wall should be at
least 5cm.
Do not place washer on stage to avoid overturn. When placing washer on carpet, make sure
Note
carpet does not block air vents.
Installing the drain hose
Connect the drain hose to drain outlet, then secure
it with the metal clamp.
1. Do not seal the drain hose in the sewer pipe
Note
to avoid poor drainage or no drainage.
2. In case of extending the drain hose, do not
exceed 3m to avoid long drainage time.
3. The height of the drain hose should not be
more than 15cm.
Installing the water inlet hose
screw
adapter
nut
collar
loop
collar
1. The joint of water inlet hose consists
2. Pull down the collar of the inlet hose
of 2 parts, adapter and collar.
to remove the adapter.
1. Length of the faucet needs to be at least 10mm, outer diameter needs to be 24mm and below.
2. Adapter can be removed If installed on a suitable faucet.
3. Spout of faucet should be smooth and round.
4. If spout of faucet is not flat, scrape it with rasp until it is flat.
5. Remove liner if outer diameter of faucet is too big .
Before using
front/back
back/front
bottom cover
soft object
Distance between
dehydration tub and
cabinet should be same
adjustable
dehydration tub
feet
cabinet
metal clamp
adapter
adapter
liner
about 5mm
3. Loosen connectors A and B.
4
How To Use Different Washing Programs
Quick Wash Program
1. Switch power on.
2. Select Quick Wash course
by pressing Program button.
5. Washing course ends with beeping sound. Power shuts off after 30s.
1.Select water level from E.Low-Mid. This program is suitable for small load size and cleaner clothing.
Note
2.Too much of detergent will result in residual left on clothes.
3.It is advisable to adjust dosage of detergent according to load size.
Wash/Spin Program
1. Switch power on.
2. Select Wash/Spin course
by pressing Program
button.
5. Washing course ends with beeping sound. Power shuts off after 30s.
Rinse Program
1. Switch power on.
2. Select Rinse, Spin course by
pressing Program button.
5. Washing course ends with beeping sound. Power shuts off after 30s.
Operation
4. Press Start /Pause
3. Select water level by
pressing Water Level
button.
button
4. Press Start /Pause
3. Select water level by
button.
pressing Water Level button.
(Water Level selection is not
available for Spin mode.)
4. Press Start /Pause
3. Select water level by
button.
pressing Water Level
button
9