Daema DWF-1318XLE Kullanıcı Kılavuzu - Sayfa 6

Yıkayıcı Daema DWF-1318XLE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Daema DWF-1318XLE 8 sayfaları.

Sayfayı Yazdır

How to Install

Installing the bottom cover

1. Slowly lean the unit facing up/down on soft object.

2. Push the bottom cover into the base slot.

3. Use the screw to fix the bottom cover onto the base

of body (a small hole in the middle of the

bottom cover), then slowly lift up the unit.

Placing the washer

1. Install the washer, adjust the Adjustable Feet if

surface is not level. The distance between the

tub and cabinet should be the same (left & right,

front & back).

2. Distance between washer and wall should be at

least 5cm.

Do not place washer on stage to avoid overturn. When placing washer on carpet, make sure

Note

carpet does not block air vents.

Installing the drain hose

Connect the drain hose to drain outlet, then secure

it with the metal clamp.

1. Do not seal the drain hose in the sewer pipe

Note

to avoid poor drainage or no drainage.

2. In case of extending the drain hose, do not

exceed 3m to avoid long drainage time.

3. The height of the drain hose should not be

more than 15cm.

Installing the water inlet hose

screw

adapter

nut

collar

loop

collar

1. The joint of water inlet hose consists

2. Pull down the collar of the inlet hose

of 2 parts, adapter and collar.

to remove the adapter.

1. Length of the faucet needs to be at least 10mm, outer diameter needs to be 24mm and below.

2. Adapter can be removed If installed on a suitable faucet.

3. Spout of faucet should be smooth and round.

4. If spout of faucet is not flat, scrape it with rasp until it is flat.

5. Remove liner if outer diameter of faucet is too big .

Before using

front/back

back/front

bottom cover

soft object

Distance between

dehydration tub and

cabinet should be same

adjustable

dehydration tub

feet

cabinet

metal clamp

adapter

liner

about 5mm

3. Loosen connectors A and B.

How To Use Different Washing Programs

Quick Wash Program

1. Switch power on.

2. Select Quick Wash course

by pressing Program button.

5. Washing course ends with beeping sound. Power shuts off after 30s.

1.Select water level from E.Low-Mid. This program is suitable for small load size and cleaner clothing.

Note

2.Too much of detergent will result in residual left on clothes.

3.It is advisable to adjust dosage of detergent according to load size.

Wash/Spin Program

1. Switch power on.

2. Select Wash/Spin course

by pressing Program

button.

5. Washing course ends with beeping sound. Power shuts off after 30s.

Rinse Program

1. Switch power on.

2. Select Rinse, Spin course by

pressing Program button.

5. Washing course ends with beeping sound. Power shuts off after 30s.

Operation

4. Press Start /Pause

3. Select water level by

pressing Water Level

button.

button

4. Press Start /Pause

3. Select water level by

button.

pressing Water Level button.

(Water Level selection is not

available for Spin mode.)

4. Press Start /Pause

3. Select water level by

button.

pressing Water Level

button