bolid S2000-KPB Manual de instruções - Página 12
Procurar online ou descarregar pdf Manual de instruções para Unidade de controlo bolid S2000-KPB. bolid S2000-KPB 14 páginas. Executive module
Também para bolid S2000-KPB: Manual de instruções (17 páginas)
Imprimir página
5.2.8 Switch on the battery backed power supplies connected to the module or connect the power
circuits to the terminals "+Umain" and "+Uback".
5.2.9 Put the module's cover on the place, close it and seal if necessary.
5.3 Maintenance Procedure 2
5.3.1 In accordance with the engineering documentation, decide upon:
–
The type of the system where the module is used,
–
Designation of the module,
–
Which network address is assigned to the module in the system,
–
Which power supply is connected to the module,
–
Which circuits and which devices the module monitors via "loop1" and "loop2" inputs,
–
Which devices are connected to the outputs "1", "2", "3", "4", "5", and "6' of the module,
–
Which network controller or device controls the module over the RS-485 interface,
–
Which control programs are assigned to each output in the configuration chart of the module,
–
Which events (or commands of the network controller) correspond to activation of the control
program at each used module's output,
–
How to generate the command or call the event to activate the control command for each used
output.
5.3.2 Open the cover of the S2000-KPB module removing the tamper label if necessary.
5.3.3 WARNING: If the module is connected to clean agent suppression modules or other
executive devices which must not be activated during the inspection, carry out the steps 5.3.4 – 5.3.7.
5.3.4 Switch off the battery backed power supplies connected to the module or disconnect the
power circuits from the "+Umain" and "+Uback" contacts.
5.3.5 Disconnect discharge circuits from the "+" and "−" contacts of used outputs of the module.
5.3.6 Connect discharge circuit simulators to the outputs as shown in Figure 5.
12
Figure 5. The schematic of a Discharge Circuit Simulator