Douglas Dynamics DD 99494 Manual - Página 3

Procurar online ou descarregar pdf Manual para Luminária Douglas Dynamics DD 99494. Douglas Dynamics DD 99494 6 páginas. Strobe light kit stainless steel hopper spreaders

Imprimir página

Feed the electrical connector and leads from

one of the LED strobe lights through the large

hole in one of the brackets. Install the LED light

and gasket to the bracket using the supplied

#6 x 5/8" machine screws and #6 locknuts.

Repeat with the other LED light and gasket.

Strobe Light

Bracket

LED Light

w/Gasket

#6 x 5/8"

Machine

Screws

Electrical leads not shown.

Lit. No. 92945, Rev. 05

Install Harness, Relay, and Fuse Assembly

If an accessory work light has been installed

previously, the strobe light harness can be secured to

the existing work light harness. Skip to Step 3.

If no work light harness is already installed, use

the supplied ﬁ r tree mounts and cable ties to secure

the strobe light harness between the lights and the

#10 x 1"

electrical enclosure, as described below.

Machine

Screws

1. Drill 1/4" holes along both sides of the hopper as

shown. Push a ﬁ r tree mount into each hole.

NOTE: The 0.7 yd

in the end cap for use instead of drilled holes.

Electric Models

Locknut

Fir Tree

Mount and

Cable Ties

Gas/Hydraulic

Models

2. Secure the strobe light harness to the hopper with

the ﬁ r tree mount cable ties.

hopper spreader has knockouts

Fir Tree

Mount and

Cable Ties

99494

August 1, 2020