Douglas Dynamics DD 99494 Руководство - Страница 3
Просмотреть онлайн или скачать pdf Руководство для Светильник Douglas Dynamics DD 99494. Douglas Dynamics DD 99494 6 страниц. Strobe light kit stainless steel hopper spreaders
Печатать страницу7.
Feed the electrical connector and leads from
one of the LED strobe lights through the large
hole in one of the brackets. Install the LED light
and gasket to the bracket using the supplied
#6 x 5/8" machine screws and #6 locknuts.
Repeat with the other LED light and gasket.
Strobe Light
Bracket
LED Light
w/Gasket
#6 x 5/8"
Machine
Screws
Electrical leads not shown.
Lit. No. 92945, Rev. 05
Install Harness, Relay, and Fuse Assembly
If an accessory work light has been installed
previously, the strobe light harness can be secured to
the existing work light harness. Skip to Step 3.
If no work light harness is already installed, use
the supplied fi r tree mounts and cable ties to secure
the strobe light harness between the lights and the
#10 x 1"
electrical enclosure, as described below.
Machine
Screws
1. Drill 1/4" holes along both sides of the hopper as
shown. Push a fi r tree mount into each hole.
NOTE: The 0.7 yd
in the end cap for use instead of drilled holes.
Electric Models
#6
Locknut
Fir Tree
Mount and
Cable Ties
Gas/Hydraulic
Models
2. Secure the strobe light harness to the hopper with
the fi r tree mount cable ties.
3
3
hopper spreader has knockouts
Fir Tree
Mount and
Cable Ties
99494
August 1, 2020