DPA Type HMA5000 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Amplificador DPA Type HMA5000. DPA Type HMA5000 7 páginas. Two-channel hi-voltage microphone amplifier

Imprimir página

Input connector:

Modified 7-pin female XLR-connector

Output connector:

Standard 3-pin male XLR-connector

Operating temperature range:

-10° C to +55° C (+14 to 131° F)

Mains voltage: 1

00 VAC – 127 VAC and 200 VAC – 240 VAC, 50 Hz and 60 Hz

Power consumption:

Maximum 15 W

Note:

The specifications and tolerances listed, as well as performance and

stability of the HMA5000, are only guaranteed when using the dedi-

cated cables from DPA Microphones.

CHANGING THE MAINS FUSE IN HMA5000

The HMA5000 is protected with a 250 mA slow blow fuse.

The fuse is rated to give adequate protection at both 120 VAC and

230 VAC. Only the correct replacement fuse must be fitted.

WARNING! Disconnect the HMA5000 from the mains supply before

removing the instrument housing.

1. The mains fuse holder is located on the printed circuit board of the

HMA5000. To gain access, the front and rear face panels of the

HMA5000 should be removed by pulling the top and bottom bezels

off the clip on frame outwards (as shown).

2. Unscrew the two retaining screws on the metal casing of the

HMA5000

3. Gently pull out the assembly.

4. Remove the Mains Fuse with a screwdriver and insert a new Mains

Fuse likewise.