DPCAV ShutterBug Pro Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Controlador DPCAV ShutterBug Pro. DPCAV ShutterBug Pro 16 páginas. Digital camera controller

Imprimir página

TART OF

ROGRAMMING

Programming begins by holding down the pushbutton switch while you apply power to

ShutterBug Pro. Continue to press the switch until the Red LED is on. When you are

ready start programming, release the switch. Now the fun begins!

Step 1:

Depending on the operating mode, the Wake-up/Standalone interval is used to

prevent the camera's power save feature from putting the camera to sleep or to

determine the time between snapshots.

AKE

While in the R/C or external trigger mode (see Step 4), this is the delay time

before the next shutter "Keep Awake" movement. At the time interval you choose,

the Stage 1 (focus) position will be active for a moment, which keeps the camera

awake. So, to prevent your digital camera from falling asleep, set this time to be

less than the camera's maximum allowed inactivity duration. For example, if your

camera turns itself off in five minutes, then enter four presses and choose

"Minutes" in Step-2 (for four minutes). If it turns off in 60 seconds, then enter five

presses and choose "10X Seconds in Step-2 (for fifty seconds).

TANDALONE

When in the Standalone mode, this is the time delay before the next snapshot.

If you want to take a photo every five minutes, enter five presses and choose

"Minutes" in Step-2 (for five minutes). If you want a photo every two hours, enter

two presses and choose "Hours" in Step-2.

IMPORTANT NOTE: Standalone mode is automatically disabled if a R/C servo

signal has been detected. To test standalone mode after programming you must

disconnect battery power, remove the servo signal source, then reapply power.

Step 2:

This entry is a companion to Step 1. It sets the time units (resolution) for the

Camera Wake-up/Standalone Interval. For example, press three times for

minutes.

Camera Wake-up/Standalone Interval.

Range: 1 = Turn Off, else 2 - 120

Camera Wake-up/Standalone Interval Units.

Range: 1= Seconds, 2= 10x Seconds, 3= Minutes, 4= Hours.

Page 8

Sep-15-2013