Bosch DISHWASHER Instruções de funcionamento - Página 14

Imprimir página

Bosch DISHWASHER Instruções de funcionamento

aus

Washing the dishes

A qua sensor *

A q u a s e n s o r

* depending on model

The Aqua sensor is an optical measuring

device (light barrier) which measures the

turbidity of the rinsing water.

The Aqua sensor is used according to the

programme. If the Aqua sensor is active,

"clean" rinsing water can be transferred to

the next rinse bath and water consumption

can be reduced by 3–6 litres. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In the

automatic programmes the temperature

and running time can also be adjusted to

the degree of soiling.

Switching on the appliance

– Turn on the tap fully.

– Close the door.

– Switch on ON/OFF switch (.

The Cleaning display )" flashes.

– Rotate programme selector 8

to the required programme.

– Press START button @.

The Cleaning display )" is lit. The

programme starts running.

T imer programming *

T i m e r p r o g r a m m i n g

* depending on model

You can delay the start of the programme

by 3, 6 or 9 hours.

– Switch on ON/OFF switch (.

– Keep pressing the Preselected starting

time button H until the appropriate

display 3h, 6h or 9h is lit.

– Press START button @, timer

programming is activated.

– To delete the preselected starting time,

keep pressing the Preselected starting

time button H until none of the

displays 3h, 6h or 9h is lit.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when neither

of the two displays h or )" is lit.

Note

To save energy, the dishwasher

automatically switches off after the end

of the programme.

Interrupting the programme

– Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave the

door ajar for several minutes and then

close. Otherwise, expansion (pressure)

may cause the appliance door to

spring open or water to run out of the

appliance.

– To continue the programme, switch on

the ON/OFF switch ( again.

T erminating the programme

T e r m i n a t i n g t h e p r o g r a m m e

(Reset)

– Press START button @ for

approx. 3 sec. until all displays go out.

– The remaining programme sequence

for draining the residual water takes

approx. 1 minute.

Changing the programme

When the START button @ has been

pressed, the programme cannot be

changed.

The only way a programme can be

changed is by Cancel programme (Reset).