Bosch DISHWASHER Manual de Instruções - Página 15

Imprimir página

Operating the Dishwasher

Start the dishwasher

Open the door and press the [On/Off] button. The LED of the last selected cycle flashes.

Select a cycle and desired options.

Press [Start] and close the door to begin the cycle.

Cancel a cycle

Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.

Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".

Close the door and wait about 1 minute while the dishwasher drains.

Open the door and press the [On/Off] button.

Interrupt a cycle

Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.

Press the [On/Off] button to turn the unit off.

To resume the cycle, press the On/Off button and close the dishwasher door.

Setting the amount of rinse aid

The amount of rinse aid dispensed can be set from "r:00" to "r:06".

To change the setting:

Open the door and press the [On/Off] button.

Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".

Release both buttons.

Press the "A" button until the display shows "r:05".

Press the "C" button to select the desired setting.

"r:00" = dispenser is OFF

"r:01" = lowest setting

"r:02" = low setting

"r:03" = medium setting

"r:04" = medium/high setting

"r:05" = high setting

"r:06" = highest setting

Press [Start] to save the setting and close the door.

InfoLight

An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the LED is not visible.

To change the setting:

Open the door and press the [On/Off] button.

Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".

Release both buttons.

Press the "A" button until the display shows "1:01".

Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.

To set delay start:

Open the door and press the [On/Off] button.

Press the [+] button until the display jumps to "h:01".

Press the [+] or [-] button until the displayed time corresponds with your requirements.

h:01 = 1 hour delay

h:24 = 24 hour delay

Press [Start] to activate delay start.

To cancel delay start:

Press the [+] or [-] button until "h:00" is indicated on the digital display.

Press [Start] to save setting and close the door.