Bosch SB Series Manual de instruções - Página 23

Imprimir página

To change the setting:

1. Press programme button 3.

Each time the button is pressed,

the set value increases by one level;

when the value of :

reached, the display jumps back

to :

2. Press START button h.

The set value is saved.

Switching off the appliance

Short time after the end of the

programme:

1. Switch off ON/OFF switch (.

2. Turn off the tap (not applicable if

Aqua-Stop fitted).

3. Remove the utensils when they have

cooled down.

Note

When the programme ends, leave

the appliance to cool down a while

before opening it. This will prevent

steam from escaping and causing long-

term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave

the door ajar for several minutes and

then close. Otherwise, expansion

(pressure) may cause the appliance

door to spring open or water to run

out of the appliance.

2. To continue the programme, switch

on the ON/OFF switch ( again.

has been

Operating the appliance

T erminating the programme

T e r m i n a t i n g t h e p r o g r a m m e

(Reset)

1. Press START button h for

approx. 3 sec.

The numerical display )*

indicates :

2. The programme sequence lasts

approx. 1 min. On the digital

display )* is indicated :

3. Switch off ON/OFF switch (.

Changing the programme

When the START button h has been

pressed, the programme cannot be

changed.

The only way a programme can be

changed is by Cancel programme

(Reset).

Intensive drying

The final rinse uses a higher

temperature which improves the drying

result. The running time may increase

slightly. (Caution if utensils are delicate!)

1. Close the door.

2. Switch on ON/OFF switch (.

3. Hold down programme button #

and press START button h until

the digital display )* : ... is

indicated.

4. Release both buttons.

The LED for button # flashes and

the digital display )* displays the

factory setting :

5. Press programme button # until

the factory set value :

indicated on the digital display )*.

To change the setting,

1. Press the button 3 to switch the

Intensive drying on :

2. Press START button h.

The set value is saved.

or off :