Bosch Series 4 Manual do utilizador e instruções de instalação - Página 24

Imprimir página

Bosch Series 4 Manual do utilizador e instruções de instalação

en Installation instructions

Installation instructions

Observe this information when installing the appliance.

19.1 General installation instructions

Follow these instructions before you start with

the installation of the appliance.

¡ The safe operation of this appliance can

only be guaranteed if it has been installed

to a professional standard in accordance

with these installation instructions. The in-

staller shall be liable for damages incurred

as a result of incorrect installation.

¡ Check the appliance for damage after un-

packing it. Do not connect the appliance if

it has been damaged in transit.

¡ Before starting up the appliance, remove

any packaging material and adhesive film

from the cooking compartment and the

door.

¡ Observe the installation sheets when in-

stalling accessory parts.

¡ Fitted units must be heat-resistant up to

90 °C, and adjacent unit fronts up to

70 °C.

¡ Do not install the appliance behind a decor-

ative door or the door of a kitchen unit.

There is a risk of overheating.

¡ Cut-out work on the units should be carried

out before installing the appliance. Remove

any shavings. Otherwise, the correct opera-

tion of electrical components may be ad-

versely affected.

¡ The mains socket for the appliance must

either be located in the hatched area

outside of the area where the appliance is

installed.

Any unsecured units must be secured to

the wall using a standard bracket ⁠ .

¡ Wear protective gloves so that you do not

cut yourself. Parts that are accessible dur-

ing installation may have sharp edges.

¡ Dimensions of the figures in mm.

19.2 Appliance dimensions

You will find the dimensions of the appliance here

19.3 Installation below a worktop

Observe the installation dimensions and the installation

instructions when installing below a worktop.

¡ To ventilate the appliance, the intermediate floor

must have a ventilation cut-out.

¡ In combination with induction hobs, the gap

between the worktop and appliance must not be

sealed using additional strips.

¡ The worktop must be secured to the built-in unit.