Bosch 800 Series Manual de instruções de instalação - Página 7

Electrical Requirements

The unit requires a 120 volt, 60 Hz, 15 AMP (minimum) circuit. It is recom-

mended that the unit be installed on a separate circuit that serves only this

appliance.

This appliance is fitted with a 3-prong grounded electrical plug. Do not modify

the plug or use an adapter. If the plug does not fit with the available recep-

tacle, have a licensed electrician install a properly grounded outlet before

proceeding with the installation. The power cord length is approximately 46".

Installer - show the owner the location of the circuit breaker or fuse. Mark it for

easy reference.

Note: If you have any questions about the grounding or electrical instructions,

consult a qualified electrician or service person.

* Can also be installed using an electrical outlet in an adjacent cabinet within the area where the provided electrical cord can reach.

Always check electrical codes for requirements.

1. Place the drawer adjacent to the wall or cabinet

opening. Plug the power supply cord into the

electrical outlet.

2. Carefully guide the drawer into the prepared open-

ing. Avoid pinching the cord between the oven and

the wall.

3. Slide the drawer all the way until the mounting

flange makes contact with the face of the cabinet

for standard installation or side cleats for flush

installation. See Figure 7A.

4. Open the drawer. Using the 4 holes on the drawer

as a template, pre drill the cabinet using a

See Figure 7A.

5. Secure the drawer with the 4 screws supplied. See

Figure 7B.

6. Test operation to confirm that the Drawer Micro-

wave is functioning properly and the drawer opens

and closes freely.

English 7

" bit.

Suggested electrical

outlet location*

Figure 6

Figure 7A

Parts supplied

4 Screws

Figure 7B

Cleat

Mounting

flange