Anchor AF-4003 Manual de configuração rápida - Página 5
Procurar online ou descarregar pdf Manual de configuração rápida para Sistemas de filtragem de água Anchor AF-4003. Anchor AF-4003 9 páginas. Under counter water filter system
Também para Anchor AF-4003: Manual de instruções de instalação (10 páginas), Manual de configuração rápida (9 páginas)
Imprimir página
2. Feed-Water Supply Installation
CAUTION: The water supply to the unit MUST be from the COLD-WATER
LINE. HOT WATER will severely damage the system.
1) Locate the cold water (angle) shut off valve (see picture below)
underneath the sink and turn it off. Open the cold-water faucet to
release the pressure. On single-handle kitchen faucets, the hot water
may have to be turned off to prevent
any hot water cross over. If
water continues to come out
of faucet with angled valve
turned off, the house main
must be turned off.
2) Locate the feed-water adapter in
the installation kit.
Please see the following for flex line
and solid-copper riser installation.
Note:
You may need to use Teflon tape on feed adapter to prevent leaks
a. Flex Line: Loosen nut and separate the cold-water riser tube from
faucet shank. Gently bend riser tube so that feed adapter fits into
faucet shank. Reinstall riser tube onto feed connector and tighten.
b. Solid-Copper Riser Tube: Follow same procedure as for flex tubing
above, except cut a piece of the riser tube so the feed adapter can
fit between faucet and riser tube.
3) Once the feed water adapter has been installed, connect the red/
orange tubing to the feed valve as in Figure 2.
Fits Both 1/2" NPT
and 3/8"
Compression Cold
Water Supply
Figure 2
5