Alentec & Orion 24720 Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Instrumentos de medição Alentec & Orion 24720. Alentec & Orion 24720 8 páginas. In line meter
Imprimir página
Manual 24720_EN_2B
1. Introduction
The In line meter 24720 is used to measure the volume of fluid filled in an object. The meter is based on the "oval-gear"
Principe. It uses permanent magnets and REED-switches as signal pickup.
The integrated valve is pressure balanced to enable a smooth flow control almost independent of fluid pressure.
It is manufactured with small tolerances to assure a high degree of accuracy over a wide range of flow and viscosity.
To conserve battery the meter goes into sleep mode after 1 minute of inactivity. All data is stored so if it is waken up again it
continues from where it was.
2. Mechanical installation
The meter is delivered in an environmental adapted paper box. The inlet and outlet of the meter is male G1/2 with inside 60°
cone to fit standard hydraulic 60° cone adapters. Use liquid sealant if additional sealant is needed.
Note!
–Do not use Teflon tape or other solid thread sealants and do not use excessive torque for the
fittings!
3. Batteries
2 pieces of AAA 1,5 V batteries are used as power source. They are placed in a battery holder. To get access to the battery
holder, loosen the screw on the front of the meter.
How to use
4.
Always read the manual before using the meter.
4.1. Check before use
The meter will probably be in sleep mode when you grab it so press the RESET or SELECT button
to wake it up. Then the display should look like this.
4.2. Dispense fluid
To dispense fluid press the <RESET> or <SELECT> button to wake the meter up if it is in sleep mode or just continue the
last dispense. If a new dispense is to be started press <RESET> button after wake up to zero the meter.
3(8)