Alentec & Orion 24720 Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Messgeräte Alentec & Orion 24720 herunter. Alentec & Orion 24720 8 Seiten. In line meter

Manual 24720_EN_2B

1. Introduction

The In line meter 24720 is used to measure the volume of fluid filled in an object. The meter is based on the "oval-gear"

Principe. It uses permanent magnets and REED-switches as signal pickup.

The integrated valve is pressure balanced to enable a smooth flow control almost independent of fluid pressure.

It is manufactured with small tolerances to assure a high degree of accuracy over a wide range of flow and viscosity.

To conserve battery the meter goes into sleep mode after 1 minute of inactivity. All data is stored so if it is waken up again it

continues from where it was.

The meter is delivered in an environmental adapted paper box. The inlet and outlet of the meter is male G1/2 with inside 60°

cone to fit standard hydraulic 60° cone adapters. Use liquid sealant if additional sealant is needed.

Note!

–Do not use Teflon tape or other solid thread sealants and do not use excessive torque for the

fittings!

2 pieces of AAA 1,5 V batteries are used as power source. They are placed in a battery holder. To get access to the battery

holder, loosen the screw on the front of the meter.

Always read the manual before using the meter.

The meter will probably be in sleep mode when you grab it so press the RESET or SELECT button

to wake it up. Then the display should look like this.

To dispense fluid press the <RESET> or <SELECT> button to wake the meter up if it is in sleep mode or just continue the

last dispense. If a new dispense is to be started press <RESET> button after wake up to zero the meter.

3(8)