AND UA-704 Manual de instruções - Página 10
Procurar online ou descarregar pdf Manual de instruções para Monitor de tensão arterial AND UA-704. AND UA-704 16 páginas.
Também para AND UA-704: Manual de instruções (16 páginas)
6. Press the exhaust valve button to completely release
air from the cuff.
When a measurement is made with insufficient
pressure, the
pressurize the cuff to a pressure. Stop squeezing
the rubber bulb when the
When a measurement is made with an erratic pulse
or in a very noisy environment,
7. Turning the power off
the
Press
START
The device will be in standby mode.
8. Subsequent measurements
If a subsequent measurement is required, turn off the power and turn it on
again. When "0 " is
Note: Allow at least three minutes between measurements on the same person.
9. Automatic power-off function
If the device is left on after a measurement, it will turn off automatically
after about one minute. It may be turned off at any time by pressing
button
START
Notes For Proper Measurement
Sit down in a comfortable position. Place the arm to be used for the
measurement on a table or other support so that the center of the cuff will
be at the same height as your heart.
Relax for about five or ten minutes before taking a measurement. If you
are excited or depressed by emotional stress, the measurement will
reflect this stress as a higher (or lower) than normal blood pressure
reading and the pulse reading will usually be faster than normal.
Your blood pressure varies constantly, depending on what you are doing
and what you have eaten. What you drink can have a very strong and
rapid effect on your blood pressure.
Measurement
mark will be displayed. Re-
mark disappears.
button
to turn the power off.
displayed
, the device is ready for another measurement.
.
ENGLISH 8
will display.
From previous page
Press exhaust valve
Bulb
Releasing air
from the cuff
button
START
the