Carmanah R247 Manual do Proprietário - Página 6

Procurar online ou descarregar pdf Manual do Proprietário para Equipamento de iluminação Carmanah R247. Carmanah R247 15 páginas. Solar led roadway light / 24-hour hazard flasher

Imprimir página

Owner's Manual | Model R247

3. Fasten the top arm pipe to the mounting bracket using the hardware described in

Drawing R247-A01_02 found at the end of these instructions.

4. Remove the large locking nut on the top arm and pass the LED harness into the top

hole of the LED array. Replace the locking nut back onto the top pipe from inside the

LED array housing. Do not fully tighten, as aiming is required when completed.

5. Fasten the lower arm to the mounting bracket, and to the lower side of the LED array

housing.

6. Connect the LED Array harnesses inside the housing.

7. Aim the LED array in the desired direction and then tighten the two locking nuts inside

the housing.

2.5

Install and Connect the Batteries

1. Remove the top cover of the main unit. There are two (2) metal battery brackets inside

– remove the four (2) nuts and washers holding each bracket and remove the bracket.

2. Remove the cover of the circuit board box (in the center of the main EMS Housing

Assembly). Notice that the LED harness is already connected to the card.

3. Each battery has two harnesses, one male and one female. With the connectors of the

card facing toward you, join the male connector of the right-side battery to the female

connector of the left-side battery. Now insert the remaining male harness connector of

the left-side battery into the circuit board using the left-most card connector, denoted as

"Battery". The right-side battery will have a harness that is unused. See Figure 3.

Document number: MAN_ROAD R247 Owner's Manual 37224_vE

Last revised: November 7, 2006

Figure 2