Bosch Household Appliances WTC82100US Manual de instruções de funcionamento, cuidados e instalação - Página 18

Procurar online ou descarregar pdf Manual de instruções de funcionamento, cuidados e instalação para Secador Bosch Household Appliances WTC82100US. Bosch Household Appliances WTC82100US 24 páginas. Condensation dryer
Também para Bosch Household Appliances WTC82100US: Manual de instruções de funcionamento, cuidados e instalação (24 páginas), Manual de instruções de funcionamento, cuidados e instalação (24 páginas), Manual de instruções de funcionamento, cuidados e instalação (24 páginas), Manual de instruções de funcionamento e instalação (24 páginas)

Imprimir página
Bosch Household Appliances WTC82100US Manual de instruções de funcionamento, cuidados e instalação

Cleaning the air cooler

3-4 times a year or if Filter flashes
continuously after the fluff filter has
been cleaned.
1. Leave the dryer to cool down.
2. Residual water may escape,
place an absorbent cloth under
the maintenance flap.
3. Unlock the maintenance flap.
4. Completely open maintenance
flap.
5. Turn both locking levers
towards each other.
6. Remove the front insert.
7. Pull out the air cooler.
18
i
Do not damage the air cooler!
Clean with warm water only;
do not use hard/sharp edged
objects!
8. Clean the air cooler completely,
drain thoroughly.
9. Clean the seals.
10. Re insert the air cooler, making
sure that the air cooler handle is
oriented to the bottom of the
unit as shown in the illustration
above.
11. Turn both locking levers ti lock
the air cooler in place.
12. Close the maintenance flap
until it locks into position.
Cleaning the moisture
sensor
Occasionally the moisture sensor
has to be cleaned because a fine
layer of transparent buildup is
deposited on the sensors.
This deposit can easily be removed
by wiping the sensors (the two bars
next to the lint filter) with a cloth and
a little white vinegar.
Use white vinegar only!
Clean the moisture sensor once
a month.
Cleaning the Lint Filter
Housing
Over time, fluff from the drying
process collects in the bearing
shield.
This fluff can be easily removed
using your vacuum cleaner, at least
once a month.