Bosch Household Appliances WTC82100US Manual de instruções de funcionamento, cuidados e instalação - Página 9

Procurar online ou descarregar pdf Manual de instruções de funcionamento, cuidados e instalação para Secador Bosch Household Appliances WTC82100US. Bosch Household Appliances WTC82100US 24 páginas. Condensation dryer
Também para Bosch Household Appliances WTC82100US: Manual de instruções de funcionamento, cuidados e instalação (24 páginas), Manual de instruções de funcionamento, cuidados e instalação (24 páginas), Manual de instruções de funcionamento, cuidados e instalação (24 páginas), Manual de instruções de funcionamento e instalação (24 páginas)

Bosch Household Appliances WTC82100US Manual de instruções de funcionamento, cuidados e instalação
9. Replace the cover on the
terminal block and fasten in
place.
i
Make sure that the U.L. strain
relief clamp is outside the
cover!
The appliance is now ready to be
plugged into the 4 wire receptacle
of the power rating.
Connecting 3 wire power supply
cord
1. Remove the screws from the
cover of the terminal block
located at the top rear of the
appliance.
2. Unscrew the 2 screws labeled
L and the screw labeled N in
the terminal block and the
grounding screw - green
colored.
3. Loosen the U.L. stain relief and
remove the 4-wire power cord.
4. Save the grounding screw -
green colored.
5. With the 3-wire cord, attach
the 2 power cord outer
conductors (red and black) to
the 2 terminals labeled L and
the remaining power cord
conductor (white) to the
housing ground using the
green ground screw as shown.
6. Tighten back all 3 screws (3
Nm) so that the power
conductors are held in place
securely.
7. Check the U.L. strain relief
clamp to make sure that it is
tight and cannot be turned.
8. Replace the cover on the
terminal block and fasten in
place.

Integrated socket

This appliance is equipped with
a socket for connecting a washer
without fuses or circuit breaker.
Only the listed washer may be
connected. For all other
connections Bosch will assume no
liability.
,
CAUTION
Use copper conducters only.
Connect to a 30 A minimum
individual branch circuit, fused at
30 A maximum.
Use receptable only for:
208-240 VAC 60 Hz 11 A
washer: WFR2460UC,
WFL2060UC, WAE20060UC,
WAS20160UC, WAS24460UC.
Condensate hose
connection
The dryer must have its condensate
drain line installed and run to
a suitable drain.
The connection for the condensate
hose is located on the back of the
dryer.
Connect the condensate drain hose
to the dryer. The other end should
then be placed and secured at
nearby sink or drain.
If installed with a washer it may,
room permitting, be installed next to
the washer drain hose and drained
to the same drain used by the
washer.
Be sure to follow all local codes
and regulations in running the
condensate to a suitable drain.
9