Dremel DigiLab 3D45 Manual de Calibração

Procurar online ou descarregar pdf Manual de Calibração para Impressoras 3D Dremel DigiLab 3D45. Dremel DigiLab 3D45 2 páginas. Print removal
Também para Dremel DigiLab 3D45: Manual de início rápido (2 páginas), Instruções de serviço (4 páginas), Manual de instruções (2 páginas), Manual (4 páginas), Manual de serviço (4 páginas), Manual de início rápido (2 páginas)

Having the correct nozzle gap is vital to achieving successful prints. The nozzle gap, also referred to as Z-Gap, is

the distance of the nozzle to the build platform when the first layer is being printed. It is important to ensure that

the first layer sticks well to the build platform, therefore, the nozzle gap needs to be ideal. Too large of a nozzle

gap may lead to a not well adhered first layer, leading to object shifting, and a too small nozzle gap may lead to a

non-visible first layer, possibly leading to clogging issues.

Please click here for Video Tutorial

Step 1: Go to Calibrate screen

From printer home screen, navigate to tools, calibrate,

and then assisted nozzle calibration. Advanced users

can use the nozzle gap calibration directly (non-assisted

mode).

TOOLS

Advanced users can move to Step 4.

Step 2: Open Assisted Nozzle

Calibration screen

a. Apply glue on the build platform. See glue application

bulletin.

b. Ensure leveling switch is free of glue residue and that

the filament has been loaded.

c. Level the build platform if needed.

Step 3: Assisted Nozzle Calibration

a. Nozzle will start heating up in order to perform the

calibration.

b. In this process, three small rectangles will be printed

side by side. Rectangle A will be printed with an off-

set of +0.1mm from the current setting, Rectangle B

will be printed with no offset, and Rectangle C will

be printed with a -0.1mm offset. An additional

rectangle will be printed enclosing Rectangles A, B,

3D45 Nozzle Gap Calibration

SERVICE INSTRUCTIONS

CALIBRATE

ASSISTED NOZZLE

CALIBRATION

and C in order to prime the nozzle and make sure fil-

ament is flowing correctly before starting the print.

Step 4: Nozzle Gap Calibration Analysis

a. Once the print has been completed, there will be

three

different

rectangles

different Nozzle Gap offsets.

representing

three