Bosch 2 Manual de Instruções - Página 8

Imprimir página

What to do if...

Water is leaking out.

– Attach/replace the drainage hose correctly.

– Tighten the screw connection of the supply hose.

No water supply.

– Start/Pause

Detergent not dispensed.

– Tap not turned on?

– Filter blocked? Clean the filter

– Supply hose kinked or trapped?

Washing machine door

– Safety function active. Programme stopped?

cannot be opened.

– - - - - (Rinse stop = no final spin) selected?

Programme does not start. – Start/Pause

– Washing machine door closed?

– Childproof lock active? Deactivating

Detergent solution is not

– - - - - (Rinse stop = no final spin) selected?

drained.

– Clean the detergent solution pump

– Clean the waste pipe and/or drainage hose.

Water not visible in the

– Not a fault - water below the visible area.

drum.

Spin result not satisfactory.

– Not a fault - the imbalance monitoring system has interrupted the spin

Laundry wet/too damp.

because the laundry is unevenly distributed.

Distribute large and small items of laundry evenly in the drum.

– Speed selected too low?

The programme duration

– Not a fault - the programme cycle is optimised for the particular

changes during the wash

washing process. This can cause changes in the programme duration

cycle.

on the display panel.

Spin cycle performed

– Not a fault - unbalanced-load detection system is adjusting the

several times.

imbalance.

Residual water in the

– Not a fault - the action of the care product is not affected.

compartment for care

– Clean the insert if necessary

products.

Odour formation in the

– Run programme

washing machine.

detergent.

Status display

flashing.

– Too much detergent used?

Appliance has detected a

Mix one tablespoonful of fabric softener with ½ litre water and pour

detergent overload.

into compartment II (Not for outdoor fabrics, sportswear fabrics or

those made with down.)

–

Reduce the detergent dosage for the next wash cycle

Loud noises, vibrations and

– Are the appliance feet fixed?

"wandering" during the

Secure appliance feet

spin cycle.

– Transportation safety devices removed?

Remove transportation safety devices

Display panel/indicator

– Power cut?

lamps do not function

– Circuit breakers tripped? Switch the circuit breakers back on or

during operation.

replace.

– If the fault occurs repeatedly, call the after-sales service.

Programme sequence

– Not a fault - unbalanced-load detection system is adjusting the

longer than usual.

imbalance by repeatedly redistributing the laundry.

– Not a fault - foam detection system active - adds an additional rinse

cycle.

There are detergent

– Occasionally, phosphate-free detergents contain water-insoluble

residues on the laundry.

residues.

– Select Rinse

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to Off and remove the mains plug from the socket.

– Turn off the water supply and call the after-sales service

not selected?

page 11.

page 4.

page 3,4.

or Ready in

time selected?

page 5.

page 3, 4.

page 11.

page 5.

page 10.

Cottons 90 °C without laundry. Use standard

Installation instructions.

or brush down the laundry after washing.

Installation instructions.

Washing machine

WAB20267IN

en operating instructions