Bosch 2 Manual do utilizador e instruções de instalação - Página 41

Imprimir página

Bosch 2 Manual do utilizador e instruções de instalação

Fault

Detergent or fabric

softener drips off the

seal and collects on

the door or in the seal

fold.

The spin result is not

satisfactory. The laun-

dry is too wet/too

damp.

Detergent residue on

the damp washing.

Detergent residue on

the dry laundry.

Water is leaking out at

the water inlet hose.

Cause and troubleshooting

Too much detergent/fabric softener in the detergent

drawer.

When dosing liquid detergent and fabric softener,

▶

observe the marking in the detergent drawer and

do not dose above this.

A low spin speed is selected.

The next time you run a wash cycle, set a higher

▶

spin speed.

Start the Spin programme.

▶

Drain pipe or water outlet hose is blocked.

Clean the drain pipe and the water outlet hose.

▶

Drain pipe or water drain hose is caught or jammed.

Ensure that the drain pipe and water drain hose are

▶

not kinked or trapped.

The unbalanced load detection system has interrupted

the spin cycle because the laundry is unevenly distrib-

uted.

Redistribute the laundry in the drum.

▶

Note: Where possible, mix large and small items in

the drum. Different sized items of laundry distribute

themselves better during the spin cycle.

Start the Spin programme.

▶

Unbalance load detection system is using a reduced

spin speed to eliminate an unbalance.

Redistribute the laundry in the drum.

▶

Note: Where possible, mix large and small items in

the drum. Different sized items of laundry distribute

themselves better during the spin cycle.

Start the Spin programme.

▶

Detergents may contain water-insoluble substances

that deposit on the laundry.

Start the Rinse programme.

▶

Detergents may contain water-insoluble substances

that deposit on the laundry.

Brush out the laundry after washing and drying.

▶

Water inlet hose is not correctly/securely connected.

Connect the water supply hose correctly.

→ "Connecting the water inlet hose", Page 14

Tighten the screw connection.

Troubleshooting en