Drija EUROPA 60 GAS GRILL Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Forno Drija EUROPA 60 GAS GRILL. Drija EUROPA 60 GAS GRILL 20 páginas. Gas in built oven

The apparatus was tested with G20 (2H) natural gas at a pressure of 20mbar. If it

will be used with another type of gas, its nozzle must be changed and the gas valve

adjusted.

Setting the oven burner

To adjust the oven burner, open the oven door and

proceed as follows:

 Remove all accessories (grills, shelves and

any steel corridor).

 Lift the bottom plate of the oven and remove

so that the inside of the oven is as shown in

the picture.

Minimum setting setting

The oven thermostat has a screw to regulate the minimum programming, accessible

by removing the thermostat knob. When the type of gas is changed, the minimum

programming must be adjusted following these specifications:

 Turn on the oven burner and keep it in operation at high temperatures for 10

to 15 minutes with the door closed. Then turn the knob to the minimum

temperature, remove the knob and use a flat

screwdriver to adjust. First, turn the knob

clockwise tightly counterclockwise to adjust

the flame. For natural gas you should rotate

one circle while 1/8 circle for LPG.

 When using butane gas, the set screw should

be turned fully clockwise. The diameter of the

by-pass is indicated in point "5.2, Data table

of burners and knobs".

 When using natural gas, adjust the screw so that when the thermostat knob is

turned from maximum to minimum, the flame will always remain stable and

uniform. Close the oven door and check that the burner remains lit at the

minimum setting.

Nozzle change

 Unscrew screw A from the oven burner.

 Move the burner But outside until the nozzle is

accessible.

 Use a wrench 7 to change the nozzle, setting the

correct one for the type of gas to be used. (See point

5.2 of the burners and nozzles table).

User Manual

GAS IN BUILT OVEN | EUROPA 60 GAS