Atlas DAGNY Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Ventilador Atlas DAGNY. Atlas DAGNY 10 páginas. Ceiling mounted rotational fan

Imprimir página

MAKING THE ELECTRICAL

CONNECTIONS

Warning:

The power should have already

been disconnected. Follow the steps below to

connect the fan to your household wiring. Use

the wire nuts supplied with your fan. Secure

the wire nuts with electrical tape. Make sure

there are no loose strands or connections.

NOTE: The Hand Held Remote Control units

included with your ceiling fan are equipped

with 16 code combinations to prevent possible

interference from or to other remote units. The

frequency switches on your Receiver and

Transmitter units have been preset at the

factory. Please re-check to make sure the

switches on both units are set to the same

positions. The frequency settings should be

changed only in case of interference or if a

second or more remote controlled ceiling fans

are installed in the same room. Any code

combination will operate the ceiling fan and

light as long as the Receiver and Transmitter

units are set to the same codes (Fig. 10)

1. Insert Receiver into Hanger Bracket with

the flat side of the Receiver facing the ceiling.

(Fig. 11)

2. Motor to Receiver Electrical Connections:

Connect the WH ITE wire from the fan to the

WHITE wire marked "TO MOTOR N" from the

Receiver. Connect the BLACK wire from the

fan to the BLACK wire marked "TO MOTOR

L" from the Receiver. Proceed to secure all

wire connections with the plastic wire nuts

provided. Dagny has no light, so the blue

receiver "light" wire must be capped off to

avoid electrical shock. (Fig. 12)

Note: Fan must be installed from a maximum

distance of 40 feet from the transmitting unit

for proper signal transmission between the

transmitting unit and the fan's receiving unit.

3. Receiver to House Supply Wires Electrical

Connections:

Connect

(Neutral) from the outlet box to the WHITE

wire marked "AC in N" from the receiver.

Connect the BLACK wire (Hot) from the outlet

box to the BLACK wire marked "AC in L" from

the receiver. Secure all wire connections with

the plastic wire nuts provided. (Fig. 12)

the

WHITE

wire

OUTLET BOX--..

BLACK (HOT)

RECEIVER_

BLACK ("TO MOTOR

L")

BLUE-

BLACK (MOTOR)

......

............

Figure 10

Figure 11

WHITE (NEUTRAL)

GREEN OR BARE

COPPER (GROUNO)

WHITE ("AC IN N")

WHITE ("TO MOTOR

GROUND-(3

GROUND

(GREEN) ON CEILING FAN)

WHITE (NEUTRAL)

Figure 12

N"l

WIRES