Atlas Copco PN 3500 Instruções de reparação - Página 15

Procurar online ou descarregar pdf Instruções de reparação para Perfurar Atlas Copco PN 3500. Atlas Copco PN 3500 18 páginas.

Mounting the

Insert the two disks (3) and the bolt (2) into

back gear shaft

the cylinder (1).

and the cylinder

The back gear assembly (4) can only be

inserted as follows:

Put together the cylinder (1) and the back

gear assembly (4) for adjustment before

mounting them.

Grease the striker (5) and insert it into the

cylinder (1).

Mounting the

Insert the bearing ring (1) into the motor

spindle bearing

housing (do not yet insert it all the way,

mind the right position).

Press in the bearing ring (1) as far as it will

go.

Only applicable

Fit the O-rings (8) to the pressure

for PN 3500:

sleeve (5).

Assembling the

Press the brake disk (2) into the spin-

spindle (mount-

dle (1). Mind the right position!

ing the inner

parts)

Mount the O-ring (3) on the plunger (4)

and insert the plunger into the pressure

sleeve (5). Insert the pressure sleeve into

the spindle.

Insert the washer (6) into the spindle and

mount it on top of the O-ring.

Press the locking ring (7) (round wire ring)

with aid of a used cylinder into the spindle

until the locking ring engages.

Insert the tumble drive into the cylinder

and insert them together into the gear

box.

Carry out a visual check!

Repair Instructions No.179.11/97

PN 3500 / PN 3500 X

1 2

PAGE