Atlas Copco BV Series Manual de instruções de segurança e de funcionamento - Página 11
Procurar online ou descarregar pdf Manual de instruções de segurança e de funcionamento para Ferramentas Atlas Copco BV Series. Atlas Copco BV Series 17 páginas. Beams and screeds
Imprimir página
Safety and operating instructions
5. Simultaneously turn the handle link to adjust the
work angle so the edge of the beam closest to
you is slightly raised.
Use
1. Spray form oil under the beam to stop it from
sticking to the concrete.
2. Place the beam at the beginning of the first
section.
3. Turn the handle link to obtain the optimum beam
angle on the concrete surface. See section
"Adjusting the work angle".
4. Position the handle link on your shoulder.
5. Slowly walk backwards pulling on the beam. The
footprints are removed by the beam.
6. When you smooth the next section, position the
beam so that it overlaps about 15 cm (5.9 in.)
(A) on the already smoothed surface.
When taking a break
Make sure to place the machine on the ground,
♦
so that it can not fall.
NOTICE Never use the beam to move the concrete
sideways.
Maintenance
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
10
Before starting maintenance on the machine, clean
♦
it in order to avoid exposure to hazardous
substances. See "Dust and fume hazard".
Use only authorised parts. Any damage or
♦
malfunction caused by the use of unauthorised
parts is not covered by warranty or product liability.
When cleaning mechanical parts with solvent,
♦
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦
For major service of the machine, contact the
nearest authorised workshop.
Every 10 hours of operation
(daily)
Lubrication
NOTICE Do not mix grease with different
characteristics.
It may be necessary to grease the rotation device
between the handle link and the beam after
prolonged use. Use a grease of the type Shell Regina
2 or an equivalent type of grease.
Every 75 hours of operation (or
every second week)
Every day
Clean the beam with water and a brush after use.
Hardened concrete is difficult to remove and a clean
surface is important for a good work result.
Apply a thin coat of lubricant (oil) to the beam to
facilitate the next cleaning operation.
BV 20H
A
♦
Check the nuts and bolts. Tighten them if
necessary.
Storage
♦
Clean the machine properly before storage, in
order to avoid hazardous substances. See section
"Dust and fume hazard".
♦
Always store the machine in a dry place.
© 2015 Construction Tools EOOD | No. 9800 1722 01 | 2015-04-16
BV 20H
Original instructions