DRYDEN AQUA 90028 Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Instrumentos de medição DRYDEN AQUA 90028. DRYDEN AQUA 90028 20 páginas.

11. Operation

After setting the DIP Switches to reflect the FlowVis model and Pipe Size employed in your application, the FlowVis Digital

is ready to use. No calibration or further settings are required. However, by default, the FlowVis Digital readout will display

the flow rate in US GPM and the Turnover Rate will show --- (indicating that this function is not activated). If you would like to

change the unit of measurement from US GPM to either LPM or M3/hr, and /or activate the pool Turnover Rate function, then it

will be necessary to access these functions as described in the Advanced Setup section.

Although FlowVis Digital will function as a flow meter without additional steps, there are several very useful features that can

be accessed via the 'advanced setup' procedures. These features comprise:

•

Display of the pool turnover rate

•

Changing the display's appearance at a user-defined flow rate

•

Programming an (optional) auxiliary relay to operate external equipment such as a Heater or Chemical Feed System,

which will only operate at user defined flow rates

Programming the advanced features will require a Windows-based laptop PC. The initial step is to download the Advanced

Panel Display Software from the internet, we recommend that this be done in an office environment rather than the pool

equipment room. Note: there is no requirement to connect the laptop to the Display during this initial step.

The laptop PC will require the following:

•

Running either a Windows 7, 8, or 10 operating system, using either a 32 or 64-bit configuration

•

Microsoft .NET Framework (if you don't have this, it can be downloaded from www.microsoft.com/net)

•

A spare USB 2.0 port (for later connection to the Display)

•

An internet connection