DSPM UniMeasure HX-VP510 Series Manual de instalação - Página 3

Procurar online ou descarregar pdf Manual de instalação para Transdutor DSPM UniMeasure HX-VP510 Series. DSPM UniMeasure HX-VP510 Series 3 páginas.

Imprimir página

HX-VP1010 Series Installation Guide

Model HX-VP1010

Model HX-VP1010-xx-

Position

See Table 1 at right for position input voltage.

Velocity

The tachometer is self energizing and requires no input

RANGE

Note: Dimensions in

2", 10"

brackets are millimeters.

3", 15", 30"

4", 20", 40"

5", 25", 50"

60"

80"

Alternate Wire Rope Exit

Via Paolo Uccello 4 - 20148 Milano

Tel +39 02 48 009 757 Fax +39 02 48 002 070

Wiring and Circuit Diagram

Position

Excitation Voltage ........ +15 & -15 VDC (±5%)

Output Impedance ....... 1.0 Ω max.

Output Load ................. 5KΩ min.

Velocity

The tachometer is self energizing and

requires no input voltage.

Option

Designator

Voltage

4.9 to 30 VDC

SI5

5 ±0.5 VDC

SI12

12 ±0.5 VDC

SI15

15 ±0.5 VDC

SI24

24 ±1.0 VDC

Dimensional Information

NOTE

Mount with Ø.25 or M6

Socket Head Cap Screws.

Alternate Wire Rope Exit

"A"

"B"

"C"

1.12 (28.4)

1.79 (45.5)

1.21 (30.7)

.96(24.4)

1.95 (49.5)

1.37 (34.8)

.80 (20.3)

2.11 (53.6)

1.53 (38.9)

.64 (16.3)

2.27 (57.7)

1.69 (42.9)

.49 (12.4)

2.42 (61.5)

1.84 (46.7)

.25 (6.4)

2.66 (67.6)

2.08 (52.8)

With small blade type screwdriver (.105" max. blade

width X .023" max. blade thickness), adjust the Zero

and Span controls on the transducer to set the zero

and maximum output voltages. Note: The Zero and

Span controls are somewhat interactive and may re-

quire several iterations to obtain the desired zero and

maximum voltage settings. Extend the transducer cable

(on angular position transducers, rotate shaft) to the

desired zero position (must be within 10% to 90% of

Input

the total range). Adjust the Zero control to give a zero

voltage output. Then extend the cable (on angular posi-

tion transducers, rotate shaft) to the desired maximum

position in the direction of longest possible travel (either

positive or negative) from the zero position. To obtain

maximum output voltage magnitude this position must

lie within 50% to 100% of the longest possible travel.

Adjust the Span control to the output voltage magnitude

required (+ or - 10 VDC maximum). Recheck the zero

and span settings and readjust if necessary.

NOTE

Mount with Ø.50 or M12 Socket Head Cap Screws.

Alternate Wire Rope Exit

[email protected] www.dspmindustria.it