Auber RDK-300B Manual de instruções

Procurar online ou descarregar pdf Manual de instruções para Controlador Auber RDK-300B. Auber RDK-300B 4 páginas. For hot runner coil heater

Imprimir página

AUBER INSTRUMENTS

Instruction Manual

1. Introduction

This is a supplementary manual for the RDK-300B hot runner coil heater. Only

the advanced parameter settings will be covered in this manual. Please check

the main instruction manual for a quick guide. Advanced parameters are

divided into groups and can be accessed by entering a special access code.

2. Overview

2.1 Operating Mode

There are two operating modes: Standard Mode and Boost Mode.

* Controller heats the coil heater to the current set

Standard

temperature.

Mode

* Adjust the set temperature at any time by using the control

knob.

* Controller heats the coil heater to the current set

temperature.

Boost

* Quick cycling between pre-programmed standby and boost

Mode

temperature.

* Adjust standby and boost settings in the 122 menu.

* Three pre-programmed boost modes available.

2.2 Parameter Menu

All parameters are grouped into three menus; each menu has its access code.

Code

122

Boost mode parameters

166

Temperature control parameters

155

System parameters

2.3 Basic Operations

2.3.1 Switching Operating Mode

To switch between the Standard Mode and a Boost Mode, please follow the

operations described in the table and the flow chart below:

1) Rotate the control knob in either direction for at least 180° to bring up the

mode-selection menu.

2) Turn the knob slowly to change the mode (a dot will be flashing at the lower

right corner).

3) Select the mode by pressing down the control knob.

2020.05

RDK-300B Supplementary Manual

Version 1.0 (May, 2020)

Standard

Operating

Mode

Coil Temperature

6 7

knob

Rotate at

3.0 0

least 180°

SET

Standby at

B-2

Coil Temperature

8 6

3 0 0

SET

Figure 1. Flow chart of how to switch operating mode.

2.3.2 Adjusting Set Temperature

Operations to change the set temperature are different in standard mode and

in boost mode. Please see the operations described in the table below.

1) Press down the control knob to bring up a

flashing dot at the lower right corner.

Adjusting

Standard

2) Turn the knob in either direction to change

Set

Mode

the value.

Temperature

3) Save the new set value by pressing down the

knob.

1) Press down the control knob to switch

between the standby temperature and the boost

Adjusting

Boost

temperature.

Set

Mode

2) If you want to change the standby

Temperature

temperature or boost temperature, go to menu

122.

2.3.3 Accessing Parameter Menus

To access a menu, please follow the steps below:

1) Press down the control knob for 5 seconds to bring up "LCK" to the top LED.

2) Turn the knob to change the number in the lower LED to the access code of

a menu you want to enter.

3) Press down the knob to confirm and enter the menu.

4) Turn the knob to change the value of parameter; press down the knob down

the confirm the change and go to the next parameter.

WWW.AUBERINS.COM

Mode

Selecting a

Selection

different

mode

Coil Temperature

Mod

knob

Mod

knob

Rotate

std

B- 2

slowly

SET

Confirming

knob

B-2 Boost

Mode

Coil Temperature

B - 2

Wait 1

3 0 0

second

SET

Press down

P1/4