Auber RDK-300B Руководство по эксплуатации

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер Auber RDK-300B. Auber RDK-300B 4 страницы. For hot runner coil heater

Auber RDK-300B Руководство по эксплуатации
AUBER INSTRUMENTS
Instruction Manual

1. Introduction

This is a supplementary manual for the RDK-300B hot runner coil heater. Only
the advanced parameter settings will be covered in this manual. Please check
the main instruction manual for a quick guide. Advanced parameters are
divided into groups and can be accessed by entering a special access code.

2. Overview

2.1 Operating Mode

There are two operating modes: Standard Mode and Boost Mode.
* Controller heats the coil heater to the current set
Standard
temperature.
Mode
* Adjust the set temperature at any time by using the control
knob.
* Controller heats the coil heater to the current set
temperature.
Boost
* Quick cycling between pre-programmed standby and boost
Mode
temperature.
* Adjust standby and boost settings in the 122 menu.
* Three pre-programmed boost modes available.
2.2 Parameter Menu
All parameters are grouped into three menus; each menu has its access code.
Code
122
Boost mode parameters
166
Temperature control parameters
155
System parameters

2.3 Basic Operations

2.3.1 Switching Operating Mode
To switch between the Standard Mode and a Boost Mode, please follow the
operations described in the table and the flow chart below:
1) Rotate the control knob in either direction for at least 180° to bring up the
mode-selection menu.
2) Turn the knob slowly to change the mode (a dot will be flashing at the lower
right corner).
3) Select the mode by pressing down the control knob.
2020.05
RDK-300B Supplementary Manual
Version 1.0 (May, 2020)
Menu
Standard
Operating
Mode
Coil Temperature
6 7
knob
knob
Rotate at
3.0 0
least 180°
SET
SET
Standby at
B-2
Coil Temperature
8 6
3 0 0
SET
Figure 1. Flow chart of how to switch operating mode.
2.3.2 Adjusting Set Temperature
Operations to change the set temperature are different in standard mode and
in boost mode. Please see the operations described in the table below.
1) Press down the control knob to bring up a
flashing dot at the lower right corner.
Adjusting
Standard
2) Turn the knob in either direction to change
Set
Mode
the value.
Temperature
3) Save the new set value by pressing down the
knob.
1) Press down the control knob to switch
between the standby temperature and the boost
Adjusting
Boost
temperature.
Set
Mode
2) If you want to change the standby
Temperature
temperature or boost temperature, go to menu
122.
2.3.3 Accessing Parameter Menus
To access a menu, please follow the steps below:
1) Press down the control knob for 5 seconds to bring up "LCK" to the top LED.
2) Turn the knob to change the number in the lower LED to the access code of
a menu you want to enter.
3) Press down the knob to confirm and enter the menu.
4) Turn the knob to change the value of parameter; press down the knob down
the confirm the change and go to the next parameter.
WWW.AUBERINS.COM
Mode
Selecting a
Selection
different
Menu
mode
Coil Temperature
Coil Temperature
Mod
knob
Mod
knob
Rotate
std
B- 2
slowly
SET
Confirming
knob
knob
B-2 Boost
Mode
Coil Temperature
B - 2
Wait 1
3 0 0
second
SET
.
Press down
P1/4