Auber Instruments TH220 Manual de instruções - Página 3

Procurar online ou descarregar pdf Manual de instruções para Controlador de temperatura Auber Instruments TH220. Auber Instruments TH220 3 páginas. Temperature and humidity controller

Imprimir página

AUBER INSTRUMENTS

gets back to the alarm zone again, the alarm will be on again. To resume the

alarm, press the Up key, the alarm indicator will be off.

To disable the alarm, set High Limit Alarm = Low Limit Alarm.

Note 4. When The controller is used for cooling (or dehumidifying control) and

load is a compressor, it should not turn on the compressor when it is at high

pressure (just after turned off). Otherwise, it may shorten the life of

compressor. The Anti-Short Cycle Delay function can be used to prevent the

rapid cycling of the compressor. It establishes the minimum time that the output

contact remains open (after reaching cutout) before closing again. The delay

overrides any load demand and does not allow the output contact to close until

the set time-delay value has elapsed. It gives time to release the refrigerant

pressure through evaporator. It is typically set to 4-6 (minutes).

Note 5. The TSF (HSF) can be set to ON or OFF. When it is set to ON, the

output will always be on when the sensor fails; when it is set to OFF, the output

will always be off when the sensor fails.

For example, when the unit controls a refrigerator for food, you may want to set

the TSF to ON if the sensor fails to keep the food cold. When it controls a

heater, you may want to set the TSF to OFF for safety purpose.

Note 6. Menu selection parameter. tE menu is for temperature control settings;

Hu menu is for humidity control settings and SYS is for system settings. SYS

setting is only available to TH220-W model.

Note 7. Device access password (only available to TH220-W model). This

parameter is used to lock the access to parameter settings on AuberSmart

app. Please refer to figure 3.

6. How to install the sensor to the unit.

The connector of sensor contains a slot for fitting pin connection. It locates at

the bottom of the controller. It also has a spring lock to prevent disconnections

from accidental pulling on the cable.

To install the sensor to the controller: 1) Identify the key on the male sensor

connector (Figure 4, a) and the notch on the female connector (Figure 4, b). 2)

Hold the tail of the female connector, align the notch and the key, and push the

female connector forward.

To remove the connector, hold the spring-loaded collar on the female

connector and pull it back. Please see Figure 5.

2017.10

E-mail: [email protected] Tel: 770-569-8420

No part of this manual shall be copied, reproduced, or transmitted in any way

without the prior, written consent of Auber Instruments. Auber Instruments

retains the exclusive rights to all information included in this document.

(a)

WWW.AUBERINS.COM

Figure 4. Install the sensor.

Figure 5. Remove the sensor.

Auber Instruments

5755 North Point Parkway, Suite 99

Alpharetta, GA 30022, USA

www.auberins.com

(b)

(c)

P3/3