DAN DRYER FOAMTAP 382 Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Electrodomésticos DAN DRYER FOAMTAP 382. DAN DRYER FOAMTAP 382 9 páginas.

Imprimir página

GENERAL SAFETY INFORMATION

WARNING

• Turn off the power to the unit before servicing or cleaning.

• Never modify the product.

• Never insert objects into any opening in the product.

• The product is not intended for playing purposes.

• Cleaning and user maintenance must be carried out by children.

• The product may only be used for the applications described in this manual.

• Do not use any accessories not recommended by the manufacturer.

• The product should be checked on a regular basis. Never use a defective or

malfunctioning unit

• Never make alterations to the product affecting its performance. DAN DRYER's product

warranty does not cover product problems that result from misuse or alteration.

NOTE

If the power supply cord is damaged, it must be replaced immediately. Disconnect the electricity

supply cord according to instructions.

This product is not intended for use by persons (inclusive children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised

or have been given instruction concerning use of the product by a person responsible for their

safety.

Children should be supervised to ensure this product is used correctly.

INSTALLATION

• Make sure the main breaker is turned off. Installation must be carried out by a qualified

person in accordance with applicable standards in the country concerned.

1. Check the required distance from sensor to sink.

Sensor

Distance from

sensor to sink:

Ceramic ≥250 mm

Brushed steel ≥300 mm

30°

Sensor field of view:

Object distance 250 mm: D: ≤128 mm

Object distance 300 mm: D: ≤155 mm

Objects within range D may cause unintentional activation.

2. Mark the desired position on the wall and drill a

Ø35 mm diameter hole.

2. Check the required distance from sensor to sink.

Recommended wall thickness: 10-30 mm

160 mm

Sensor

19 mm

≥170 mm

30°

A minimum distance

≥180 mm

of 180 mm is required

between each tap

product.

3. Installation of the tap:

A) Push the screwed bushing through the hole

in the wall

B) Place gasket, disc, and nut on the threaded

coupling of the tap

C) Tighten with tool, be careful not to overtighten

the nut

Nut

Disc

Gasket

Recommended wall

thickness: 10-30 mm