DAN DRYER FOAMTAP 382 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Electrodomésticos DAN DRYER FOAMTAP 382. DAN DRYER FOAMTAP 382 9 páginas.

Imprimir página

INSTALLATION HEIGHT

Sensor
Nozzle
Soap: D = ≤ 350mm
Foam: D = ≤ 650mm

USER GUIDE

• Place your hands approx. 10-14 cm under the sensor to activate the
dispenser. The dispenser will deliver 1-1.5 ml soap (0.6-0.8 ml foam)
• Remove hands after soap release
• Stops automatically when hands are moved away

LIGHT INDICATOR

Standby
Solid green light
Active
Pulsing light from green to red
Wrong type of soap/obstruction
Flashing green and red light
Empty soap reservoir*
Flashing green light
* Light indication for empty soap reservoir is based on a counter that resets when power
is switched off, e.g. when refilling soap. The calculation is based on a 1.5 L soap reservoir
and will call for soap refill every 1.2 L (approx. 1000 activations). If using foaming soap
the empty reservoir indication flashes even though the reservoir is still half full. Remove
reservoir from wall bracket and place it back to reset the SoapTap unit.
8
IMPORTANT!
•
Ensure easy access to maintenance
and cleaning of the unit.
D
•
It is recommended to install a
power switch to the soap dispenser
to ensure easy disconnection of the
electricity supply before cleaning
and maintenance.
•
Do not bend the hose too sharp. It
can increase the resistance in the
hose and reduce the ability of the
pump to deliver a full dose.
•
Ensure unit is installed on solid and
stable background.
•
Pay attention to the different
properties of the different liquids,
depending on the type of pump.

CLEANING AND MAINTENANCE

Routine cleaning and maintenance is recommended.
REFILL OF SOAP RESERVOIR
• Remove soap reservoir and pump unit from the control box
• Remove pump from soap reservoir and fill with soap
• Put the pump back in the filled reservoir. Install soap reservoir and pump in the control box
• NB! Do not remove the soft hose from the pump
CLEANING AND MAINTENANCE OF CONTROL BOX
• Cut the power
• Remove any dust and dirt
• Do not rinse with running water
• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with
an abrasive effect
CLEANING AND MAINTENANCE OF TAP/SENSOR
• Do not rinse with running water
• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with
an abrasive effect
• Clean sensor for dust and dirt to prevent unintentional activation
9