Concoa 537 Series Manual de Instruções de Instalação e Operação - Página 10
Procurar online ou descarregar pdf Manual de Instruções de Instalação e Operação para Interruptor Concoa 537 Series. Concoa 537 Series 20 páginas. Autoswitch systems
Também para Concoa 537 Series: Manual de instruções de instalação e funcionamento (17 páginas)
Imprimir página
Recommended Installation
TB1-19
TB1-20
TB1-9
TB1-10
10. Connect the power source; turn on the remote alarm's power switch (switch up). The power LED's on the
autoswitch and the remote alarm should illuminate.
11. Check the function of the switchover system by pressurizing both sides and allowing one side to depressurize
at a time. When the right bank is low (below the alarm set point on the gauge), the right LED will illumi-
nate on the remote alarm and the autoswitch. The buzzer will sound if no other alarm LED's are on. The
buzzer may be silenced on the remote alarm by pressing the remote alarm's silence button. Check the left
side of the system in the same manner.
CONNECTING THE 529 5305 SECONDARY REMOTE ALARMS
TO THE 529 5298 REMOTE AND 529 5300 REMOTE ALARM
The following components are required to install the secondary remote alarm:
one 529 5298 or 529 5300 remote alarm connected to at least one autoswitch
secondary remote alarm (529 5305)
small flat-tip screwdriver (customer supplied)
cable (customer supplied) 22 gauge wire recommended
The terminal view of the 529 5298 & 529 5300 remote alarm will look like the diagram shown in Figure 7. The
connections to the remote alarm will use the labeled terminal blocks shown in the diagram showen in Figure 7. The
terminals will be shared with those that connect to the autoswitch.
The terminal view of the 529 5305 secondary remote alarm will look like the diagram shown in Figure 8.
Figure 7. 529 5298 and 529 5300 remote alarm terminals
10
+24VDC
Red wire
GRND
Black wire
+24VDC
Red wire
GRND
Black wire