AOG L series Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para grelha AOG L series. AOG L series 2 páginas. Stand alone outdoor gas grill
Também para AOG L series: Manual de início rápido (2 páginas), Manual de início rápido (2 páginas)

Imprimir página

Note: For infrared burner (IR) equipped

grills, see detailed instructions

included in your owner's manual.

Fig. 4-1

Cooking grid

Vaporizer panel

(not with IR)

Main burner

Warming

rack

Igniter

switch

Drip tray

heat shield

Drip tray

Read setting

Read setting here

here

OFF

Fig. 5-1 - Burner valve control knob

WHEN OPERATING THIS

APPLIANCE WITH PROPANE,

ALL INSTRUCTIONS AND

WARNINGS MUST BE

OBSERVED. FAILURE TO DO

SO MAY RESULT IN A FIRE

OR EXPLOSION CAUSING

SERIOUS INJURY OR DEATH.

The light switch is push button operated,

and is located on the right side of the

control panel (see Fig. 5-2). It controls the

power to all lights.

6-Propane Safety

FOR PROPANE CONFIGURATIONS; READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE

GAS FOUND IN YOUR OWNER'S MANUAL.

REV 0 - 1611140830

Backburner

(if equipped)

Grill lights

(not shown)

Rotisserie kit

(if equipped)

Wire

harness

Light

extension

switch

5-Test

Note:

Grill must be connected to 120VAC power for electronic lighting.

1. Open lid(s) or remove cover(s) from burner(s) to be lit.

2. Turn all gas control knob(s) to their OFF position(s).

3. Turn on the gas at its source.

Note: DO NOT turn on more than one valve at a time for either electronic or manual lighting.

HIGH to

High to

LIGHT

light

Depress the control knob for the burner to be lit and turn it to the HI LIGHT position, then

press the ignition button. Once the burner lights, release the ignition button.

CAUTION:

If a burner does not light within ﬁ ve (5) seconds of turning on the control knob, depress

the knob and turn it to the OFF position. WAIT FIVE (5) MINUTES before repeating step

4. If the burners still do not light after several attempts, refer to the grill owner's manual

for manual lighting.

5. Repeat step 4 for each additional burner to be lit.

Fig. 5-2

Ignition

switch

Left

main burner

control knob

and 36

4-Grill Setup

Parts Placement Checklist

Place the following items according to their position and orientation in

Fig. 4-1:

Vaporizer panels, cooking grids, and warming rack.

Leave pre-installed burners in place to maintain proper alignment.

Vaporizer Panels

Place the vaporizer panels directly onto the studs on the burners.

The panels allow heat from the burners to be evenly distributed

throughout the cooking area.

Cooking Grids

Place the cooking grids (over the burners) onto the grill frame.

Warming Rack

The warming rack comes pre-installed. Remove zip ties before use.

Consult the owner's manual to remove or replace.

The burner ports and

carry-over ports must

be kept clean to ensure

Replacement parts can be ordered

from your local AOG dealer.

Power supply

Center main burner

control knob

Drip

tray

model controls

proper ignition and

operation.

Right

main burner

Backburner

control knob

(if equipped)

Control panel

screw(s)

Light switch

L-C2-481