AOG L series Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для гриль AOG L series. AOG L series 2 страницы. Stand alone outdoor gas grill
Также для AOG L series: Краткое руководство по эксплуатации (2 страниц), Краткое руководство по эксплуатации (2 страниц)
Печатать страницу
Note: For infrared burner (IR) equipped
grills, see detailed instructions
included in your owner's manual.
Fig. 4-1
Cooking grid
Vaporizer panel
(not with IR)
Main burner
Warming
rack
Igniter
switch
Drip tray
heat shield
Drip tray
Read setting
Read setting here
here
OFF
Fig. 5-1 - Burner valve control knob
WHEN OPERATING THIS
APPLIANCE WITH PROPANE,
ALL INSTRUCTIONS AND
WARNINGS MUST BE
OBSERVED. FAILURE TO DO
SO MAY RESULT IN A FIRE
OR EXPLOSION CAUSING
SERIOUS INJURY OR DEATH.
The light switch is push button operated,
and is located on the right side of the
control panel (see Fig. 5-2). It controls the
power to all lights.
6-Propane Safety
FOR PROPANE CONFIGURATIONS; READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE
GAS FOUND IN YOUR OWNER'S MANUAL.
REV 0 - 1611140830
Backburner
(if equipped)
Grill lights
(not shown)
Rotisserie kit
(if equipped)
Wire
harness
Light
extension
switch
5-Test
Note:
Grill must be connected to 120VAC power for electronic lighting.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO NOT turn on more than one valve at a time for either electronic or manual lighting.
HIGH to
High to
LIGHT
light
Depress the control knob for the burner to be lit and turn it to the HI LIGHT position, then
4.
press the ignition button. Once the burner lights, release the ignition button.
CAUTION:
If a burner does not light within fi ve (5) seconds of turning on the control knob, depress
the knob and turn it to the OFF position. WAIT FIVE (5) MINUTES before repeating step
4. If the burners still do not light after several attempts, refer to the grill owner's manual
for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
Fig. 5-2
Ignition
switch
Left
main burner
control knob
30
and 36
"
4-Grill Setup
Parts Placement Checklist
Place the following items according to their position and orientation in
Fig. 4-1:
Vaporizer panels, cooking grids, and warming rack.
Leave pre-installed burners in place to maintain proper alignment.
Vaporizer Panels
Place the vaporizer panels directly onto the studs on the burners.
The panels allow heat from the burners to be evenly distributed
throughout the cooking area.
Cooking Grids
Place the cooking grids (over the burners) onto the grill frame.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use.
Consult the owner's manual to remove or replace.
The burner ports and
carry-over ports must
be kept clean to ensure
Replacement parts can be ordered
from your local AOG dealer.
Power supply
Center main burner
control knob
Drip
tray
model controls
"
proper ignition and
operation.
Right
main burner
Backburner
control knob
control knob
(if equipped)
Control panel
screw(s)
Light switch
L-C2-481