Free The Tone FF-1Y Manual do Proprietário - Página 9
Procurar online ou descarregar pdf Manual do Proprietário para Equipamento de gravação Free The Tone FF-1Y. Free The Tone FF-1Y 12 páginas. Rf phase modulation delay
Também para Free The Tone FF-1Y: Manual de início rápido (2 páginas), Procedimentos de atualização do firmware (10 páginas)
Imprimir página
Assigning Functions to PRESET SELECT/TAP Switch
The FF-1Y can assign various functions to the PRESET SELECT/TAP switch.
1. Simultaneously press the PRESET SELECT/TAP and PRESET switches for about 2 seconds.
2. The display shows the function assigned to the PRESET SELECT/TAP switch.
3. Turn the PARAMETER encoder until the desired function is shown in the display.
4. Press the PARAMETER encoder to confirm.
List of Assignable Functions p.20
MIDI Setups
Setting up MIDI Receiving Channel
Upon receiving a program change number included in a MIDI signal from an external MIDI device, the FF-1Y switches
presets instantly.
1. Turn on the power to the unit while holding down the PRESET SELECT/TAP switch.
2. When the unit boots up, release the PRESET SELECT/TAP switch.
3. Turn the PARAMETER encoder until the desired MIDI receiving channel is shown in the display.
4. Press the PARAMETER encoder to confirm.
NOTE
A receiving channel can be set to 1–16 channel and Omni mode (factory default) in which all channels are received. In Omni mode, the
display shows "ALL." When set to "oFF," no MIDI signal is received.
Transmitting Data to/from an External Device
The FF-1Y can save or recall preset contents to/from a personal computer. For connection and setup procedures,
please confirm with the product or support page of the Free The Tone website.
Updating Firmware
The firmware of the FF-1Y can updated. For the latest firmware or connection and setup procedures, please confirm
with the product or support page of the Free The Tone website.
Initializing
Perform the following steps to reset to the factory setting. All presets are cleared and returned to factory defaults.
1. Turn on the power to the unit while holding down the DISP and SAVE switches at the same time.
2. Release the switches when the display shows "Int."
3. Press the PARAMETER encoder to execute the initialization.
16
Block Diagram
17