Free The Tone MC-3 Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Equipamento de gravação Free The Tone MC-3. Free The Tone MC-3 10 páginas.

The MC-3 has the following two operation modes.

1) MODE-1: Program Change Number Send Mode

Press the INC  or DEC  switch and recall the desired program change number. The display flashes

during selection. When the desired program change number is shown, press the ENTER switch to send

the MIDI signal. If the display is flashing, then the MIDI signal is not sent, but it will be sent when the

ENTER switch is pressed.

2) MODE-2: Preset Mode

For each of SW1–SW3, you can preset a program change number or control change number. Note that

you cannot send both a program change number and a control change number at the same time. At

the moment you press one of the switches, the MIDI signal configured for that switch is sent.

Available parameters are as follows.

• When sending a program change number:

Program change number 001–128

NOTE: The MIDI channel to be used will be the send channel set in the Edit menu.

• When sending a control change number:

Control change numbers off, 000–120, MIDI channels CH1–CH16,

Switch operation type: LATCH, MOMENTARY, ON SEND

HOW TO USE

The MC-3 provides the following two ways to configure presets:

1) Edit presets in Edit mode (refer to 7-3. Edit mode on p.14)

2) Configure presets directly without entering Edit mode

Now let's look at how to configure a preset directly.

Press the desired footswitch (SW1, SW2, SW3) for about 3 seconds.

The display flashes [ pgm ].

If you want to set a program change number, press the ENTER switch and set the number to be sent

(proceed to step

If you want to set a control change number, press the INC switch to show [ ctl], press the ENTER

switch, and set the number to be sent (proceed to step

• To set a program change number

A program change number can be set in the range of 001–128. Use the INC and DEC switches to

select the desired number and press the STORE switch. When the configuration completes

successfully, the display shows [ --- ].

• To set a control change number

Use the INC and DEC switch to select the desired number and press the ENTER switch. Then set the

MIDI channel.

A MIDI channel can be set from CH1 to CH16. Use the INC and DEC switches to select the desired

channel and press the ENTER switch. Then set the operation type of the switch.

Set from the operation type from the following three types: [ ltc] (LATCH), [ mom ] (MOMENTARY),

and [ ons ] (ON SEND).

Use the INC and DEC switches to select the desired type and press the STORE switch. When the

configuration completes successfully, the display shows [ --- ].