aevit 2.0 Manual de instalação - Página 14
Procurar online ou descarregar pdf Manual de instalação para Suporte para TV aevit 2.0. aevit 2.0 17 páginas. Mounting brackets
Imprimir página3. SECONdArY INpUT
3.1 gENErAL INFOrMATION
The secondary input section will describe how to install the mount-
ing brackets for the AEVIT 2.0 Display and switches to operate the
secondary functions of the vehicle. Generally, the AEVIT 2.0 Display
is mounted to the same quick Adjust Upper Pole as the AEVIT 2.0
Wheel as shown in Figure 31; however, with the hardware provided,
it can be installed just about anywhere. Section 3.3 will discuss
mounting the switches that control the secondary functions of the
vehicle. These include: Digitone 2.0, VIC 2.0, plus others.
3.2 dISpLAY BrACkET INSTALLATION
Before installing the Display Mounting system, verify that the following components are included with the BRKT-
AEVIT-DISP mounting kit:
(1) Display Vertical Support
(2) Input Device Mounting Balls
(1) Mounting Ball hardware Kit
sTEP 1
Attach (1) mounting ball to the AEVIT 2.0 Display (see
page 1 for instructions). Determine a location to attach the
second mounting ball to the quick Adjust Upper Pole. This
bracket was designed such that the mounting ball can be
mounted anywhere along the quick Adjust Upper Pole.
sTEP 2
Mark and Drill (3) 3/16" thru holes into the quick Adjust
Upper Pole and install the second mounting ball to the
bracket (hardware not included).
sTEP 3
Mount the Display to the Display Vertical Support and the
Vertical Support to the Mounting Ball that was installed in
step two (Figure 32).
sTEP 4
The standard length of the Display Vertical Support is 8" .
Other lengths are available on special order. Contact EMC
SALES at (207) 512-8009 for more information.
ALL MOUNTING hARDWARE AND FASTENERS MUST BE PROPERLy TIGhTENED TO PRE-
VENT UNINTENDED MOVEMENT OF ThE INPUT DEVICE(S) OR DISPLAy. FAILURE TO
OBSERVE ThIS WARNING MAy RESULT IN AN ACCIDENT CAUSING SERIOUS INjURy AND/
FIGuRE 31
(BrkT-AEVIT-dISp)
IF ANy OF ThESE COMPONENTS ARE NOT IN-
CLUDED WITh ThE BRKT-AEVIT-DISP, CALL ThE
EMC SERVICE DEPARTMENT. DO NOT ATTEMPT
AEvIT 2.0
DIsPlAy
MOuNTING
DIsPlAy
vERTICAL
suPPORT
QuIck ADjusT
uPPER POlE
FIGuRE 32
WARNING:
OR DEATh.
AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL
Mounting Brackets
NOTE:
TO INSTALL WIThOUT ALL PARTS.
BALL
3-1
AEvIT 2.0
DIsPlAy
HARDwARE FOR
INSTALLINg SECOND
MOuNTING bAll, Is
NOT INcluDED