Consort Claudgen QZWP45N Series Instruções - Página 4

Procurar online ou descarregar pdf Instruções para Aquecedor Consort Claudgen QZWP45N Series. Consort Claudgen QZWP45N Series 5 páginas. Infrared ip55 heater

Imprimir página

6. LAMP REPLACEMENT

Note: Before examining or carrying out any maintenance ensure the heater has cooled down and is disconnected from the mains supply.
The lamps used in the fitting are robust and if knocks and shock vibrations are avoided, will last for around 5000 hours.
Please ensure you have the correct replacement lamp (see list below) before starting to dismantle the fitting.
6.1 TO REPLACE LEFT OR RIGHT LAMPS
a) Disconnect the heater from the power supply by unplugging from the mains socket and wait until the body has cooled down.
b) Remove the end cap nearest the lamp you need to replace by undoing the 2 socket head screws at the end.
c) Slide out the end cover plate and remove the guard and end reflector.
d) Remove the other end reflector
e) Unclip the faulty lamp from the spring clips at each end, allowing the lamp to move forward clear of the back reflector.
f)
Unclip the reflector from the heater casing and remove.
g) Now slid out the next cover plate making sure you don't drop the guard from the centre lamp. Gently remove the centre guard.
h) Remove both end reflectors from the centre lamp.
i)
Remove the centre lamp back reflector by getting you fingers behind the reflector and unclipping it from its locating slot.
j)
Disconnect the faulty lamp wires from the terminals located in the electrical box on the rear of the heater, and then remove the
lamp.
k) Insert the wires of the new lamp through the holes in the heater body to the electrical box and reconnect them into the terminals.
Ensure that the terminals are tightened correctly to make a good electrical connection.
l)
Re-assemble in the opposite order making sure all the parts are replaced and the guards are in position.
WARNING! Failure to reassemble all the parts and use the guards will invalidate any remaining guarantee and may make the unit
dangerous.
6.2 TO REPLACE CENTRE LAMP
a) Disconnect the heater from the power supply by unplugging from the mains socket and wait until the body has cooled down.
b) Remove both end caps by undoing the 2 socket head screws at each end.
c) Slide out both the end cover plates, remove the guards and end reflectors.
d) Unclip both end lamps from their spring clips, allowing the lamp to move forward clear of the back reflector.
e) Unclip the reflectors from the heater casing and remove.
f)
Now slid out the remaining 2 cover plates making sure you don't drop the guard from the centre lamp. Gently remove the centre
guard.
g) Remove both end reflectors from the centre lamp.
h) Remove the centre lamp back reflector by getting you fingers behind the reflector and unclipping it from its locating slot.
i)
Disconnect the faulty lamp wires from the terminals located in the electrical box on the rear of the heater, and then remove the
lamp.
j)
Insert the wires of the new lamp through the holes in the heater body to the electrical box and reconnect them into the terminals.
Ensure that the terminals are tightened correctly to make a good electrical connection.
k) Re-assemble in the opposite order making sure all the parts are replaced and the guards are in position.
36000405
4