AudioRealism Bass Line Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Software AudioRealism Bass Line. AudioRealism Bass Line 18 páginas. A monophonic programmable synthesizer plug-in

Imprimir página

Synthesizer Section

Synthesizer settings are modified by clicking on the switch(es) or knobs and dragging the
mouse. The controls from left to right are:
Waveform - Click the waveform control to toggle between sawtooth and
squarewave. ABL's waveforms are modeled from analog synthesizers and have a
liquid quality to them.
Tuning - The tuning control has a two octave range. To make fine tuning
adjustments, hold down the <Shift> key while adjusting the tuning knob. ABL's
default tuning is set to A-220Hz.
Cutoff - The cutoff control sets the basic cutoff frequency of the VCF. Since the
ABL filter is a low pass filter, all frequencies above the cutoff frequency will be
attenuated. Attenuation can be 18dB/octave or 24dB/octave.
Resonance - Resonance emphasizes certain frequencies around the cutoff point.
This makes the sound brighter and also affects the envelope of the accent.
Envmod - Envelope modulation determines how much movement there should be
in the cutoff frequency. Envelope modulation is bipolar in ABL, thus it modulates
the cutoff positively and negatively with the basic cutoff as center point.
Decay - Decay control sets the speed of the envelope. Turning the knob clockwise
will increase decay time, while turning counterclockwise will shorten the decay
time
Accent - The accent control sets the amount of accent for those steps which have
accent programmed on them. Turning the knob clockwise increases the effect of
accents.
Drive - The knob controls the drive of the signal being fed into the distortion
circuit. This only has any effect if the distortion knob is not fully counter
clockwise.
Distortion - The distortion circuit is activated when the knob is not positioned
fully counterclockwise (in its minimum position). Increasing the distortion will
make the sound harsher. The most 303 like setting is approximately 20%
distortion.
Volume - The volume control simply affects volume. When the volume is set to
75% or more the sound will begin to clip. This is also the nature of the original
Bass Line.
Bass Line – User's Manual
9