Contacta STS-K001L Manual de instalação e do utilizador - Página 7
Procurar online ou descarregar pdf Manual de instalação e do utilizador para Sistema de intercomunicação Contacta STS-K001L. Contacta STS-K001L 16 páginas. Window intercom system bridge bar kit
Imprimir páginaCustomer/Visitor Side Installation
1. Place the bridge bar on the counter top in a central location over the
pass-through tray.
2. Disassemble the speaker pods by undoing the screws and removing the
housing.
Allen grub
screws
3. If the bridge bar needs to be narrowed, calculate the width required
(minimum: 450mm) with the following steps:
a. Locate the allen grub screws on the mounting bracket and loosen
them to allow the brackets to slide along the tube.
b. Slide the brackets inwards until the desired width is obtained. Ensure
the microphone stem is an equal distance from both brackets.
c. If necessary, use a hacksaw to cut the bridge bar to the counter's
required length. Be careful to avoid any damage to wiring.
d. Ensure the brackets are in the desired location and re-tighten the
grub screws.
4. Place the mounting brackets adjacent to either side of the pass-through.
They should be approximately 2-3mm away from the screen.
5. Mark the four fixing points and two cable management holes to be
drilled.
Housing
fixing points
Allen grub
screws
7