- ページ 7

インターホン・システム Contacta STS-K001LのPDF インストレーション＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Contacta STS-K001L 16 ページ。 Window intercom system bridge bar kit

Customer/Visitor Side Installation

1. Place the bridge bar on the counter top in a central location over the

pass-through tray.

2. Disassemble the speaker pods by undoing the screws and removing the

housing.

Allen grub

screws

3. If the bridge bar needs to be narrowed, calculate the width required

(minimum: 450mm) with the following steps:

a. Locate the allen grub screws on the mounting bracket and loosen

them to allow the brackets to slide along the tube.

b. Slide the brackets inwards until the desired width is obtained. Ensure

the microphone stem is an equal distance from both brackets.

c. If necessary, use a hacksaw to cut the bridge bar to the counter's

required length. Be careful to avoid any damage to wiring.

d. Ensure the brackets are in the desired location and re-tighten the

grub screws.

4. Place the mounting brackets adjacent to either side of the pass-through.

They should be approximately 2-3mm away from the screen.

5. Mark the four fixing points and two cable management holes to be

drilled.

Housing

fixing points

Allen grub

screws