4DRC 4D-V30 Manual de Instruções - Página 6

Procurar online ou descarregar pdf Manual de Instruções para Quadricópteros 4DRC 4D-V30. 4DRC 4D-V30 16 páginas.

8. Remote control battery installation:
Instructions in charging:
● Do not put the charged battery in a place with high temperature
and heat, such as an open flame or an electric heating device,
otherwise damage or explosion may occur.
● Do not hit or beat the surface of hard objects with the battery.
● Do not disassemble the battery.
● Do not immerse the battery in water, and please store the battery
in a dry place.
● Do not leave battery alone when charging.
9. Environmental requirements before flight:
Please choose an outdoor and open environment with no rain and snow and low wind. Please stay
away from crowds, trees, wires, tall buildings, airports, and signal transmission towers when flying. Do
not fly in a too small indoor environment with lots of things.
10. Preparation instructions before flight(using remote control):
10.1 Aircraft frequency matching: Turn on the power of the
aircraft and place it on a horizontal surface. At this
time, the aircraft placed on the horizontal surface will
automatically enter the frequency matching state, and
the front white light and the rear red light will flash.
Note: Set the aircraft in a correct direction, and the nose
shall face forward. It must be placed on the horizontal
plane.
10.2 Turn on the remote control (default mode): long press
the power switch button
and the indicator flashes; push the throttle lever up to
the top (step 2) and then to the bottom (step 3), and
thus the frequency matching is successful, the UAV
lights change from flashing to being permanently on.
The aircraft/remote controller must ensure sufficient power or it cannot take off!
Warning
Battery cover
AAA battery
(step 1), turn on the power
05
Battery installation:
8.1 Remove the battery cover.
8.2 According to the polarity instructions on
the battery compartment, remove the
battery cover on the back and insert a
2X "AAA" battery (not included).
1. The positive and negative poles and the positive and
negative poles of the battery box must be identified when
inserting the battery, and error is not allowed.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
When not flying, please do not install
the battery in the aircraft to avoid
battery damage.
2
3
1
Note
Warning