Agri-Fab 45-02101-101 Manual do Proprietário - Página 7
Procurar online ou descarregar pdf Manual do Proprietário para Espalhador Agri-Fab 45-02101-101. Agri-Fab 45-02101-101 12 páginas. Pro 125# broadcast spreader
Também para Agri-Fab 45-02101-101: Manual do Proprietário (12 páginas), Manual do Proprietário (12 páginas)
Imprimir páginaFor Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
24. Assemble the flow control gauge onto the flow control
mounting bracket using a 1/4" x 3/4" carriage bolt, a
nylon washer and the hand knob. See figure 11.
25. Push the flow control arm forward to the off position and
slide flow control mounting bracket toward hopper until
closure plate (bottom of hopper) is fully closed. Carefully
tighten the 1/4" hex lock nuts without deforming the
slots. The closure plate should open half way when the
flow control gauge is set at "5". Reposition the flow
control mounting bracket as necessary. See figure 11.
NYLON
WASHER
FLOW CONTROL
GAUGE
1/4" x 3/4"
CARRIAGE BOLT
MOUNTING BRACKET
FIGURE 11
26. Attach an angle stop bracket (inside) and a swivel
bracket (outside) to the rear hole in the R.H. shield
bracket using a 1/4" x 3/4" hex bolt, two 5/16" washers,
a nylon washer and a 1/4" hex lock nut. Tighten the
locknut so that the swivel bracket can pivot freely. See
figure 12. Repeat step on L.H. shield bracket.
27. Attach a swivel bracket to the front hole in the R.H. shield
bracket using a 1/4" x 3/4" hex bolt, two 5/16" washers,
a nylon washer and a 1/4" hex lock nut. Tighten the
locknut so that the swivel bracket can pivot freely. See
figure 12. Repeat step on L.H. shield bracket.
5/16"
WASHER
1/4" HEX
LOCK NUT
ANGLE STOP
BRACKET
FIGURE 12
HAND KNOB
OFF
1/4" HEX
LOCK NUTS
FLOW CONTROL
1/4" x 3/4"
HEX BOLT
NYLON
WASHER
NYLON
WASHER
SHIELD
BRACKET
SWIVEL
BRACKET
www.mymowerparts.com
28. Assemble the spreader shield to the front swivel brack-
ets using two 1/4" x 3/4" carriage bolts, 5/16" washers
and the two 1/4" plastic knobs. See figure 13.
29. Assemble the spreader shield to the rear swivel brackets
using two 1/4" x 3/4" hex bolts, four 5/16" washers and
two 1/4" hex lock nuts. Tighten the locknuts so that the
swivel bracket can still pivot freely. See figure 13.
5/16" WASHER
1/4" LOCK NUT
FIGURE 13
30. Place the hopper screen down into the hopper to help
break up clumpy material and to prevent large clumps
from reaching the bottom of the hopper and clogging the
opening. See figure 14.
FIGURE 14
7
PLASTIC
KNOB
1/4" x 3/4"
HEX BOLT
1/4" x 3/4"
CARRIAGE BOLT
HOPPER SCREEN